Softwre evluate system for Software class C for MCU.docVIP

Clause Requirement – Test Error/fault Verdict  GENERAL Classification Class C Control functions which are intended to prevent special hazards (e.g., explosion of the controlled equipment). Examples of controls which may include class C functions are: automatic burner controls and thermal cutouts for closed water heater systems (unvented). The definition in EN 60335-1 software class B software that includes code intended to prevent hazards if a fault, other than a software fault, occurs in the appliance software class C software that includes code intended to prevent hazards without the use of other protective devices Controls with functions declared as software class C shall have one of the following structures: 常用 -single channel with periodic self-test and monitoring P 不常用 -dual channel (homogenous) with comparison N/A 不常用 -dual channel (diverse) with comparison N/A Example of measures to control faults/errors in a single chip(8 bit) -single channel with periodic self-test and monitoring 1 CPU Register including (HCS08). : 1. Accumulator (A) 2. Index Register (H:X) 3. Stack Pointer (SP) 4. Program Counter (PC) 5. Condition Code Register CPU Registers DC fault Stuck at（a fault model representing an open circuit or a non-varying signal level These are usually referred to as stuck open, stuck at 1 or stuck at 0. 代表输出常为“1”或“0” Periodic self-test using walkpat memory test H.2.19.7: Initialize memory to all zeros. Write 1 into location, and read all other locations, to ensure that they still contain all 0s. Verify location 1. Return location 1 to 0, and continue till the end. Repeat all for the walking 0. 1.2 CPU/instruction decoding and execution Periodic self-test using equivalence class test with values inside, outside and at the limits of the specified ranges: H.2.18.5 the instructions are grouped as follows: move instructions arithmetic instructions bit and shift instructions conditional instructions other instructions 1.3 CP