大学毕业论文__基于单片机节能路灯.docVIP

摘 要 本设计完成了以AT89S52单片机和DAC0832数模转换芯片为核心的LED路灯低功耗智能控制装置。该设计由供电模块、LED恒流驱动电源模块、单片机控制模块、路灯信号检测模块、LCD显示模块、声光报警模块、按键模块、温度感应模块组成。单片机根据声光传感器对路边状况的检测和时钟芯片DS12C887设置的时间来控制D/A转换芯片,与LED恒流驱动共同实现LED路灯亮度的自动调节，通过控制继电器实现LED路灯的开关，并用二极管组成保护电路。开灯、关灯时间以及即时时间动态显示。当路灯出现电路故障时，还会出现声光报警。 论文详细论述了控制系统的组成、相关硬件和软件的设计、工作原理。重点介绍了如何运用AT89S52控制DAC0832芯片实现LED驱动电路。 关键词 恒流驱动；电路故障；液晶显示；保护电路；声光控制 Abstract The core LED street lamp low power consumption intelligent control device is completed with AT89S52 SCM and DAC0832 analog-to-digital conversion chips. The design is composed of power supply module, LED by constant current drive power supply module and single-chip microcomputer control module, street lamp signal detection module, LCD display module, sound and light alarm module, key module, temperature sensing module. SCM is according to sound and light sensor to curb status of detection and clock chip DS12C887 setup time to control the D/A conversion chip and LED constant current driver together to accomplish the street lamp brightness LED the automatic adjustment,through the realization of the control realy LED lamp switch,and of the diode protection circuit. Turn on the light, turn off the lights and instant time to get the time dynamic display.When street light appeared circuit fault, the design also can appear sound and light alarm. The control system of the composition, the hardware and software of the relate design and work principle are introduced in the paper. And the method of how to use AT89S52 devices control chip realize DAC0832 LED drive circuit is emphasized. Key words Constant Current Drive Circuit Fault LCD Display The Protection Circuit Sound And Light Control 目 录 摘要 I Abstract II 第1章 绪论 1 1.1 课题来源及研究的目的和意义 1 1.2 国内外在该方向的研究现状及分析 1 1.3 本课题研究的主要内容 2 第2章 本设计用到的主要元器件 3 2.1 数模转换芯片 3 2.2 52单片机 4 2.2.1 AT89S52的特点 4 2.2.2 管脚说明 5 2.3 驻极体话筒 6 2.4 光敏电阻 7 2.5 电磁继电器 7 2.6 时钟芯片 7 2.7 本章小结 9 第3章 硬件电路的原理与设计 10 3.1 概述 10 3.2 系统设计原理框图 10 3.3 供电模块 11 3.4 单片机控制模块 11 3.5 LED恒流驱动电源模块 12 3