第2章 Hysys软件的使用解析.ppt

* * * - Tell them that they can use this page as a guide when doing the following workshop. * - Tell them that they can use this page as a guide when doing the following workshop. * Stream - Composition basis can be changed. - If using a -FRAC basis, then total flowrate is needed. - If fractions don’t add up to 1, then there will be a warning and values will be normalized. - Note that pressure can be in absolute or gauge units (new for 9.3). - Show the two different ways to get to the stream input, other than the next key (I.e. from the Data menu and from the graphical worksheet). - Show the units at the top of the input form. * * * * Block input - For each block, there is both required and optional information. * * * * * * * * * * Results - forms: status, stream-summary, results for each block - control panel - history file is similar to what is on the control panel - report file and input file can be exported * * Results - forms: status, stream-summary, results for each block - control panel - history file is similar to what is on the control panel - report file and input file can be exported * 探 讨： 上机实习二 由于GasWell 3的组份列表当中包含一些水，所以不能用相图工具执行物流在各种压力下的泡点和露点计算；所以，请用属性表(Property Table)工具完成压力从100kpa到10000kpa的泡点和露点曲线。 tools ? Utilities ? Property Table 等值线 横坐标 纵坐标 每次上课练习结果提交： 所有结果用WinRar软件压缩打包 提交文件名：“学号+姓名+第？章.rar 提交地址：hgsj06@163.com 主题：化工设计作业（第？章） （必须） 需收到自动回复方可确定提交成功！若无自动回复，请检查邮箱名称后再发。 来不及完成的练习，最晚提交时间不得晚本周日晚11时(以邮件发送时间为准 过期限再后提交-1分/次，未交-2分/次) 内容错误享受 “未交” 待遇 内容不全享受 “迟交” 待遇提交文件要求： 考勤： 01张三.doc 作业： 01张三 （第2章）.rar 如果分次提交，请再标注 * * * * * * * * * * * * * * * * - This workshop builds on the graphical flowsheet created in the last workshop. - Optional part is for those who finish early. It is not necessary to complete them. * Remind them to save the file since it will be used in the next workshop. * * * * * Components Main form - show partial matching - search for a component by name and by formula - mention type of component - different databanks - spacebar clears a fi