FCC Prt 15 Subpart C.pptVIP

Measurement Standards Restricted bands of operation (FCC 15.205) Spectrum Management 為保護無線頻率之稀有資源，應予珍惜並審慎規劃管理以其發揮最大效用，國際電信聯合會（International Telecommunications Union, 以下簡稱ITU）為確保無線電頻率之合理使用，並避免不同國家無線電電台間發生妨礙性干擾，將全世界劃分為三區，並依各類業務特性劃分為固定、行動、廣播電視、業餘、航空、衛星、助航、定位等共三十七種業務，實施無線電頻率之分配及無線電頻率指配之登記，並制訂無線電規則（Radio Regulation），供各國制訂其國內規則參考 Test at limit distance to extent practical Test at limit distance to extent practical Ex:123KHz Field Strength=2400/F(123KHz)=19.51(uV/m) AV Limit=20log(19.51)+20log(300/3) 2 =25.80+80 =105.8 ( dBuV/m ) PK Limit=Av limit+20=105.8+20=125.8 ( dBuV/m ) Exploratory Radiated emission measurements Occupied Bandwidth Duty Cycle Antenna selection for radiated emissions testing FCC Test Items and Spec. (2) FCC 15.231 FCC Test Items and Spec. (2) FCC Test Items and Spec. (2) Power limit Measurement for output power (FHSS device) Measurement for output power (DSSS device) Measurement for occupied bandwidth Measurement for peak power density Measurement for Band Edge (A) Measurement for Band Edge (B) Measurement for frequency stability The END 1.Perform an in?band field strength measurement of the fundamental emission using the RBW and detector function required by C63.4 and our Rules for the frequency being measured. 2. For transmitters operating below 1 GHz, use a 120 kHz RBW with a CISPR QP detector (a peak detector with 100 kHz RBW may alternatively be used). 3. For transmitters operating above 1 GHz, use a 1 MHz RBW, a 1 MHz VBW, and a peak detector (as required by Section 15.35). Repeat the measurement with an average detector (i.e., 1 MHz RBW with 10 Hz VBW). Note: For pulsed emissions, other factors must be included. 扦爷熔擒漂硅茶址蓟足游拯毛爱甄恫叛足洗曲贼轰滥咀伏吐惩奴大氏仁祟FCC Part 15 Subpart CFCC Part 15 Subpart C 4. Choose a spectrum analyzer span that encompasses both the peak of the fundamental emission and the band-edge emission under investigation. Set the analyzer RBW to 1% of the total span (but never less than 30 kHz) with a vide