gas aalyzer technical__ specification for cement kiln.docVIP

PS6500 Gas Analysis System for Cement Kiln Technical Specification Chongqing Sichuan Instrument Analyzer Co., Ltd.  TABLE OF CONTENTS Chapter 1 Main specifications Chapter 2 Technical datasheet and description for kiln inlet gas analyzer Chapter 3 Delivery scope 1. Delivery scope of kiln inlet gas analyzer 2. Delivery scope of preheater outlet gas analyzer Chapter 4 Two-years spare parts 1. Spare parts along with the equipments 2. Two years spare parts Chapter 1 Main specifications 1. Main technical performance: 1.1 Zero drift: ≤±1% FS/7d 1.2 Range drift: ≤±1% FS/7d 1.3 Reproducibility: ≤ 0.5% 1.4 Working resistance: ≤ 750Ω 1.5 Output signal: 4～20 mA DC 2. Normal sample gas conditions 2.1 Sample gas temperature: ≤ 1400℃ 2.2 Sample gas pressure and fluctuation range: -10～10KPa 2.3 Dust concentration in sample gas: ≤ 2000g/m3 3. Ambient conditions 3.1 Ambient temperature: 5～45℃ 3.2 Relative humidity: ≤ 85% 3.3 Power supply: 220/380 VAC 50Hz 3.4 Power consumption: ≤5KVA 3.5 Ambient atmosphere: There should be no explosive atmosphere in environment, good ventilation. 3.6 Ambient air pressure: Absolute altitude should be less than 2500m. 3.7 Without direct sunlight radiation 3.8 Without strong magnetic interference. 3.9 Without strong mechanical vibration. 3.10 Air flowrate: ≤0.5m/s 3.11 Operation position: Horizontal position 4.Compressed air requirement The compressed air must be free from contamination as well as from oil and water droplets. It must be dried at ≤ +3 °C and have a pressure of approx. 600 kPa (approx. 4 bar positive pressure). Consumption is approx. 1 m3 / h. When the ambient temperature is below 0 °C, it is essential to ensure that the compressed-air supply cannot freeze. 5.Cooling water requirement Drinking water approx. 2-3 bar. The closed loop cooling-water circuit must be filled with approx. 1000 l of drinking water. Probe is cooled with water. 6. System safet