大学毕设论文---ca6140开合螺母的加工工艺及夹具设计.docVIP

编号： 桂林电子科技大学信息科技学院 毕业设计(论文)说明书 题 目： CA6140开合螺母 加工工艺及夹具设计 院 （系）： 专 业： 学生姓名： 学 号： 指导教师单位： 姓 名： 职 称： 题目类型：(理论研究 (实验研究 (工程设计 (工程技术研究 (软件开发 (应用研究 2014 年 5月 26日 摘 要 本毕业设计是CA6140车床上的螺母（也更准确的说法也可以称之为开合螺母）的设计，包括以下几个方面：设计的组件，计算过程和工作时间，两套夹具设计（车床，钻床，每一组），所要求的特殊夹具，和相应的制卡和简单的运动仿真。 专用夹具方案的确定方案设计方案时应遵循以下加工质量，结构尽简单，操作制造特别是老师我而言，这次毕设关键词：CA6140开合螺母;夹具设计;工艺工装设计. 　 Abstract This graduation design is on CA6140 lathe nut (also more accurately can also be called a half nuts) design, including the following aspects: the design of components, calculation process and working time, two sets of fixture design, lathe, drilling machine, each group), the required special fixture, and the corresponding fabrication and simple movement simulation. The scheme of special fixture design industry processing machinery, is very, very important one step.Special fixture scheme suitable for or not, almost all can directly determines the parts for efficient batch processing.When we sure the final design plan should follow the following rules and laws: then started the first must ensure the quality of processing, the structure of the design as much as possible, to simple, as long as meet the requirements of processing, fixture itself as a single as possible), to be simple and feasible to operate, such as the second clamping drilling machine with the same parts, must be with this in mind, or it will significantly reduce processing efficiency) the economic benefits of the manufacturing cost is higher, such as the blank casting bronze are available, and this part also can use 45 # or gray cast iron, this will determine whether conform to the principle of economic benefit.Especially our mentor teacher parker, it is at noon lunch break, but to give up their own private lunch, do you classmates for us at the