分布式能源系统-2015剖析.pptVIP

空气轴承 无需润滑油 机组唯一的运动部件: 涡轮发电机主轴 96000rpm 高速永磁发电机 微型燃气轮机介绍 簧片 轴承 主轴 专利 “电子” 齿轮箱 AC～DC～AC整流转换 适用各种不同电压 300-500 伏 适用各种频率 50-60 hz 电压及电流转换器 可直接接入电网 具有孤网运转功能 先进的电子技术 模板来自于 / * * 模板来自于 / * 模板来自于 / * Capstone is one of two companies which has implemented air-bearings in commercial applications Air bearings eliminate the need for conventional oil lubrication of any kind avoiding oil changes and reducing maintenance costs One moving part vs. 150 in reciprocating engines dramatically reduces maintenance and replacement costs The technology provides very clean emissions with less than 9 ppm of NOX while burning natural gas – which is extremely low All of this is controlled by our patented digital power controller The microturbine consist of the following: Two pole permanent magnet generator, its windings and generator shaft, compressor wheel, turbine wheel, recouperator (Air to Air heat exchanger), combustion chamber, “air bearing” system and exhaust outlet. The generator shaft, compressor and turbine wheel is a single part. This is the ONLY part that moves in the entire system. Further, it rides on a film of air, via the air bearings, virtually eliminating wear, Thus, increasing reliability and reducing maintenance. When the turbine is running, there is no contact between this single moving part and all stationary parts. Theory of operation: Air flows into the front of the turbine cooling the generator windings. The air is then compressed as it passes by the compressor wheel. The compressed air then enters the recouperator chamber where it is pre-heated by the exiting exhaust. This process adds energy to the air, expanding the air. By doing this, the turbine uses less fuel and raises the efficiency of the microturbine. The heated compressed air then enters the combustion chamber and is mixed with fuel. Rapid expansion of the gas occurs during the combustion process and it passes the by turbine wheel, spinning the turbine wheel. The turbine wheel is connect to the