CCNA思科网络技术学院教程-第4章_线缆测试及局域网、广域网布线方案.pptVIP

主要内容 介绍关于网络布线和线缆测试的知识 。 网络连接图例 4.1 线缆测试 4.2 端口识别 4.2 端口识别 1、交换机常见接口： RJ45 以太网接口， 10/100/1000BASE-TX 堆叠模块， 光纤模块， 1000BASE-SX，1000BASE-LX/LH， 1000BASE-ZX 4.2 端口识别 2、路由器常见接口： Console 端口 AUX 端口 高速同步串口 RJ45 以太或快速以太网接口 AUI 端口 ISDN 端口 4.3 局域网布线连接 2、UTP 直连（正接） 制作跳线注意 1、水晶头铜片朝上看线序 2、每根线要顶到头 3、线缆外皮要夹牢在水晶头内 4、卡线时要用力 3、UTP 跨接（反接） 4、UTP 实现直连和跨接 UTP实现设备互联 4.4 工作站和服务器 1、对等网络 2、客户/服务器网络 4.5 连接广域网 WAN Serial Implementation ofDTE versus DCE DTE/DCE—The point where responsibility passes Modular Interfaces Cabling Routers for ISDN Connections Cabling Routers for ISDN Connections (cont.) 4.6 Console 口连接 超级终端的配置（COM端口） Visual Objective Summary After completing this chapter, you should be able to perform the following tasks: Identify and connect necessary components to enable connectivity between switches and routers Identify and connect necessary components to enable WAN connectivity between over serial or ISDN BRI connections Set up console connections on routers and switches Document the physical topology of a network, including cable types and locations Review Questions 1. Does the following pinout scheme reflect a straight-through, rollover, or crossover cable? 2. What media can be used for each connector type? Blank for pagination Emphasize: Rollover cables are not the same as crossover cables. The pinouts for a rollover cable are 1-8, 2-7, 3-6, 4-5, 5-4, 6-3, and so on. Students must also set up a HyperTerminal console session if they are on a Microsoft Windows ‘95 platform. The instructions to establish a console session using HyperTerminal are in the HyperTerminal appendix. Emphasize: Stress that damage to ISDN equipment will occur if you connect non-ISDN cables to ISDN ports, interface, and switches. Transition: To configure ISDN or any network device parameters, you must have a console connection. Purpose: Review the summary items with your students. Emphasize: Read or restate the summary statements. By now, your presen