Pipe joint管道连接.pptVIP

WECO-UNION CONNECTION COFLEXIP HOSES A potential danger exists on all gas flow lines and high-pressure relief lines (basically all our flow lines FH to CM and all our Vent lines from Separator and Surge Tank). Make personnel, client and third parties aware of it ! PIPING PIPING SELECTION GUIDELINES Maximum expected WHP x 1.2 = selection of the WP of our equipment (flow head, choke manifold, pipe and other upstream equipment) - Working pressure (WP) The pressure rating of any pipework is not determine by the end connection or the pipe itself, but by the lowest rated section. - Flow Rate / Velocity The diameter of the piping depends on the maximum expected flow rate. The most common sizes of piping used is 3”. 4” or 6” diameter piping is sometimes chosen for high gas rate tests. PIPING Warning : Figure 206 Hammer Union Figure 206 piping should not be used except for 6-in 206 schedule 80 as flow lines for high rate gas test, located downstream the separator. (Pressure is a maximum of 1440 psi decreasing towards 0 psi at flare tip) Due to the nature of the 206 seal (O-ring), it is not recommended to use the piping for hydrocarbon flow. the exception to use 6-in 206 is given considering that the 6-in is not available in 602 type weco. HPHT piping (15 kpsi and above) Only metal-to-metal seal piping (Grayloc, Flanges, Dynetor…) should be used for upstream flow lines. PIPING Piping colors used are the new Schlumberger standard : The following standards would allow differentiation of both the piping service and working pressure rating: - white for nitrogen service - grey for treating iron (acid fracturing) - blue for hydrocarbon piping (Testing) = this could also be applicable to pressure control equipment (slickline wireline lubricators BOP’s…) . The stainless steel band remains to identify serial number, certification date etc… white PIPING PIPING - COFLEXIP HOSES COFLEXIP HOSES COFLEXIP hoses must be choosen in accorda