大学毕设论文-热量表的设计与实现(软件部分).docVIP

南 昌 工 程 学 院 毕 业 设 计 (论 文) 热量表的设计与实现(软件部分) The design and implementation of heat meters (software part) 总计 毕业设计（论文） 32 页 表 格 3 个 插 图 12 幅 摘要 我国北方冬季要供暖，为了节约能源，大多数地区已通过热网集中供热。但是热能作为一种商品来出售，当然要收费了。可是目前因为居民家里还没安装热量表只按建筑面积收费。但是按建筑面积收供热费显然是不合理的，应该按照用户实际用的热能来计算。热量表，是计算热量的仪表。热量表的工作原理：将一对温度分别安装在通过载热流体的上行管和下行管上，安装在流体入口或回流管上流量计发出与流量成正比的脉冲信号，一对温度传感器给出表示温度高低的模拟信号，积算仪采集来自流量和温度传感器的信号利用积算公式算出热交换系统获得的热量。一个完整的热量由三个部分组成流量传感器用以测量流经热交换系统的热水流量温度传感器分别测量供暖进水和同水温度计算显示器根据与其相连的流量传感器和温度传感器提供的流量和温度数据通过热量公式计算出用户从热交换系统获得的热量。 Winter in the northern China to heating, in order to save energy, most areas already through the network of central heating. But heat as a commodity to sell, of course, want to charge. But at present because families havent install thermal scale, had to press construction area of charges. But according to the construction area of the heating fee is clearly unreasonable, should according to actual use of heat energy users to calculate. Hot scale, is a calculation of heat meter. Heat meter principle of work: will a temperature sensor separately installs in through the heat transfer fluid on the pays and pays under, flow meter installed in fluid entrance or backflow tubes. Flowmeter issued and flow proportional to the pulse signal, a temperature sensor gives said the analog signal temperature, and integrated calculate instrument collection from flow and temperature sensor signal, using the product formula is calculated for heat exchanging system of heat. A complete hot scale consists of three parts: flow sensor to measure the heat exchange system through the hot water flow; The temperature sensor, were measured with water temperature and heating water; Calculation display, according to connected to it flow sensor and temperature sensor provide flow and temperature data, through the heat calculation of heat exchanging system users from heat gain. This paper mainly used 51 series of single chip microcomputer, flow s