0-Conclusion.docVIP

Part Five——Conclusion: 基于上述试验结果以及结果讨论，得出这次试验的结论。直截了当，逐条得出结论。 常用的描述语句（idioms）： The main conclusions can be derived from this study are as follows: It can be stated from the results of primary experiments that ……… XX were (or was ) carried out to …… The effect of XX was studied/investigated. XX studies showed that ………. It was showed that……… It was determined that …….. It was also determined that …….. It was found that …… It was also found that ……. The results presented here are based on………. The total optimum conditions that were obtained from this study occurred at 20°C，300rpm, 45min, and pH 6.5. For Example： 1. CONCLUTIONS This preliminary study demonstrates the potential for mineral separation using a method that minimizes environmental impact and can deal with fine particles. Further characterization of the system will be needed to optimize the operating window, particularly with regard to the kinetics of layer formation with fluid and particle properties. With the use of cryogenics, this process could be applied in industries where issues of contamination and product integrity are important. 这个初步的研究表明使用对环境影响小的方法分离矿物具有很大潜力，而且可以很好的分离微细颗粒。这一系统的将来需要开发好的操作窗口，特别是需要流体动力学的和颗粒的性质。由于使用低温，这一过程可以应用由污染物排放而且要求产物完整很重要的工业。 2. CONCLUSIONS While tower mills are traditionally used for grinding to P80s over 15μｍ,high-speed stirred mills offer advantages over the tower mill in this range of the ultrafine grinding spectrum.Energy requirements are reduced by using high-speed stirred mills rather than tower mills.The TsaMill may be operated in open circuit (开路)while still achieving narrow particle size distribution （粒级）.The batch（间歇性的） SMD produced a greater proportion of fines for a given P80 than the IsaMill based on specific surface area measurements.The data suggests that sulphide mineral and silica liberation is similar or better than that of the tower mills for the same grind size. The greatest benefit of reducing the grind size using the high-speed stirred mill