ANSYS与ADAMS接口示例2.docVIP

ANSYS与ADAMS接口示例 下面是一个在ANSYS中生成模态中性文件的例子： 生成模态中性文件的命令流 /title, ADAMS interface - simple connecting rod with constraint equations c*** This represents a connecting rod using the following features: c*** SOLID45 to represent the rod c*** constraint equations to represent the pin c*** MASS21 for the pin center /units,bin pi = 3.14159 /prep7 c*** define rod width, length and pin radii (all in meters) w=.015 l=.225 r1=.0125 r2=.025 c*** convert to inches w=w*39.37 l=l*39.37 r1=r1*39.37 r2=r2*39.37 mp,ex,,2.1e9*1.45e-4 mp,nuxy,,.3 mp,dens,,7800*1.94e-3/12**3/12 ! convert to pound_mass inch-based slug c*** define pins et,2,21 r,2, .001*.06852,.001*.06852,.001*.06852 type,2 real,2 n,2000 n,2001,,,.225*39.37 e,2000 e,2001 c*** define connecting rod - take into account pin radii et,1,45 type,1 real,1 n,1,-w/2,-w/2,r1 n,2,w/2,-w/2,r1 ngen,2,2,1,2,1,,w ngen,11,10,1,4,1,,,(l-r2-r1)/10 e,1,2,4,3, 11,12,14,13 egen,10,10,-1 c*** pins are rigid - use constraint equations cerig,2000,1 *repeat,4,,1 cerig,2001,101 *repeat,4,,1 c*** delete rotational CEs (to get clean run) cedel,4,6 *repeat,8,6,6 finish c*** select pin nodes and compute data for ADAMS interface nsel,s,node,,2000, 2001,1 adams,6 ! end of sample input test 在ADAMS软件中生成ANSYS所需要的载荷文件(.lod文件) 进入ADAMS程序，建立机械系统的刚性部件，读入模态中性文件.mnf以建立柔性体的模型，指定柔性体与刚性体的连结方式，按实际情况定义载荷和边界条件进行机械系统的运动学分析。在分析完成后输出ANSYS软件所需要的载荷文件(.lod文件)。此文件包含了对应于运动过程中不同时刻点柔性体的运动状态和所承受的载荷等信息(例如力,力矩，加速度，角速度及角加速度)。 下面是一个ADAMS生成的载荷文件，其中节点13001，13000为柔性体的外部节点，即为柔性体与刚体的连结点 ! ! ******** A N S Y S ******** ! ****** LOADS DATA SET FRAGMENT ****** ! Load File Created From ADAMS Analysis ! TO BE MERGED WITH ANSYS INPUT FILE! ! Created: 26 Sep 2000 17:19 ! Number of Load Cases: 101 ! Units: Mass = Kilogram ! Length = Meter ! Angle = Degree !