无线模块 发送无线模块 发送.docVIP

#includemsp430x14x.h #define INT8U unsigned char #define INT16U unsigned int #define WRITE_BURST 0x40 //连续写入 #define READ_SINGLE 0x80 //读 #define READ_BURST 0xC0 //连续读 #define BYTES_IN_RXFIFO 0x7F //接收缓冲区的有效字节数 #define CRC_OK 0x80 //CRC校验通过位标志 //无线模块引脚定义 #define GDO0 P3DIR = ~BIT1 //GDO0 #define MISO P3DIR = ~BIT3 //MISO #define CSN1 P3OUT |= BIT0; //CSN=1 #define CSN0 P3OUT = ~BIT0; //CSN=0 #define GDO21 P3OUT |= BIT2; //GDO2=1 #define GDO20 P3OUT = ~BIT2; //GDO2=0 #define SCK1 P3OUT |= BIT4; //SCK=1 #define SCK0 P3OUT