Structure during the period of construction.doc

Structure during the period of construction, geometric size control is good, the metope to vertical, level off, before decorating handle carefully at the base. Should strengthen the inspection for the work of grass-roots base, qualified rear can be carried out under the procedure. (3) carefully before construction according to the drawing size, check the actual situation of the structure construction, combined with block block brick to fine line, row, bread stick ash control points to meet the requirements. 6.3.4.3 construction technology 6.3.4.3.1 process Basic level processing - hung vertically, set square, find rules - stick ash cake to wipe the underlying mortar, play the line separating - row - leaching brick to set furring brick, brick tick off seam and seam 6.3.4.3.2 operation process (1) matrix method for the operation of the concrete wall 1) the basic level processing: will jut out metope between concrete flat, for the substrate concrete surface is very smooth to cut hair, or with mixed interface adhesive agent of fine cement mortar small hair wall, also can brush interface agent, water and moisture at the grass-roots level. 2) 10 mm thick 1:3 cement mortar matrix, should be layered points plastering mortar, along with solid, leveling with rub hair. 3) for six or seven bottom ash into works, according to the requirements of drawings, glazed tile specification and combined with the actual conditions of brick, the elastic line. 4) row: according to the details and the brick wall size in relation to the row, in order to ensure uniform tile aperture, conform to the requirements of the design drawings, pay attention to the big walls, pillars, and buttress to the brick, and in the same bearing arrangement on metope, shall have a less than l / 4 bricks of the brick. Less than a full brick row should be no secondary parts, such as Windows or internal Angle of the wall between. But also pay attention to consistent and symmetry. In case of card for outstand