nist 电容nist 电容.doc

Special Four Terminal-Pair (4TP) Capacitance and Dissipation Factor Characterization (52100S) This service covers the characterization of capacitance and dissipation factor for standard 4TP air-dielectric capacitors with nominal values of 1 pF, 10 pF, 100 pF and 1000 pF, in the frequency range from 1 kHz to 10 MHz. first, three-terminal capacitance measurements are taken at 1 kHz for each capacitor under test, thus linking these values to the NIST Calculable Capacitor. Single-port complex impedance measurements are then taken at frequencies in the 100 MHz range, linking these values to the NIST Air Line Standard. Next, a mathematical extrapolation algorithm is used to predict the 4TP resistance and inductance at the test frequencies, and finally the 4TP capacitance and dissipation factor of the capacitor under test are then computed at the test frequencies. The estimated uncertainties for the 10 pF, 100 pF and 100 pF 4TP capacitance are in the range of 20 ppm to 300 ppm at 1 MHz and in the range of 1100 ppm at 10 MHz. The 1 pF capacitance uncertainties are in the range of 700 ppm for 1 MHz and 14000 ppm (1.4 percent) for 10 MHz. Estimated dissipation factor uncertainties for the 10 pF, 100 pF and 1000 pF standard capacitors lie between 20 microradians (μrad) and 300 μrad at 1 MHz and between 600 and 1400 μrad at 10 MHz. The estimated 1 pF dissipation factor uncertainties are in the range of 300 μrad at 1 MHz and 5700 μrad at 10 MHz. It is recommended that potential customers contact A. Koffman 301/975-4518 to schedule requests for this service. The service will provide capacitance and dissipation factor characterization, with uncertainties for each, at the following frequencies: 1 kHz, 10 kHz, 100 kHz, 500 kHz, 1 MHz, 2 MHz, 3 MHz, 4 MHz, 5 MHz, 6 MHz, 7 MHz, 8 MHz, 9 MHz and 10 MHz. Additional frequencies will increase the cost. back to top of page?|?back to index of electromagnetic measurements Low-Frequency Capacitance and Inductance Measurements and Standards (5