08-02RadiographicExaminationProcedure射线检验工艺规程分析.doc

Radiographic Examination Procedure 射线照相检验工艺规程 Prepared By编制: Date日期: Reviewed By审核: Date日期: Approved By批准: Date日期: Scope 范围 This procedure is provided for x-ray radiographic examination techniques in accordance with the requirements of ASME Code SectionⅠ, VIII Division 1 , latest applicable edition and addenda. 本规程适用于按照ASME规范第Ⅰ卷、第Ⅷ卷第一分册最新版本及增补的要求进行的X射线检测。 This procedure is intended for examination of the welded joints in ASME Code vessels fabricated with steel. 本规程适用于ASME规范产品钢制容器的对接焊缝。 This procedure shall be supplemented by the examination instruction which defines the variable more specific for the job to be examined. 本规程应由具体详细的检测工艺文件的做补充。 Qualification of NDE Personnel 检测人员资格 Any NDE personnel concerning with this examination shall be qualified as radiographic examiner in accordance with Written Practice for Qualification and Certification of Nondestructive Examination (NDE) Personnel(QCD-08-01), which conforms to the requirements of SNT-TC-1A (2006) and ASME Code SectionⅠ、VIII Division 1 . 从事射线检测的人员必须按本公司《无损检测人员培训考评及认证实施细则》（文件号：QCD-08-01）进行资格评定和认证，此实施细则符合SNT-TC-1A（2006）及ASME规范第Ⅰ卷、第Ⅷ卷第一分册的要求。 Equipment, Tools and Materials 检测设备、器材 Level II examiner shall select the equipment, tools and materials in compliance with the following condition and the requirements of the examination instruction. Ⅱ级人员所选用的设备、器材应能保证符合下列条件和RT工艺卡的要求。 Radiation Source 射线源 One of the following equipment listed in Table 1 shall be used. The effective source size shall be verified and be within the specified limitation. 应选用表1中列出的设备之一，应当核对有效焦点尺寸，确认在规定范围内。 Table 1 X-Ray Equipment 表1 X-射线设备 Manufacturer 制造厂家 Brand Max. Voltage 最大管电压 (KVP) Tube Current 管电流 (mA) Source Size 焦点尺寸 (mm) 大冶泰发电子有限公司 DAYE TAIFA TELECOMMUNICATION INSTRUCMENT CO. LTD XXG3205 320KV 5mＡ ２.5×２.5 Films 胶片 The film listed in Table 2 shall be used: 应选用表2中列出的胶片。 Table 2 Films 表2 胶片Brand 类型 Manufacturer 制造厂家 Designation 标号 T３ 爱克发（无锡）影像有限公司 AGFA IMAGING PRODUCTIONS CO., LTD