[模电英文课件ch15-3.pptVIP

15.3 Nonsinusoidal Oscillators 15.3.1 Schmitt Trigger Circuits 15.3.1 Schmitt Trigger Circuits 1. Comparator 15.3.1 Schmitt Trigger Circuits Zero-Crossing Detector 15.3.1 Schmitt Trigger Circuits Review Question 15.3.1 Schmitt Trigger Circuits Review Question 15.3.1 Schmitt Trigger Circuits 2. Other Comparators 15.3.1 Schmitt Trigger Circuits 3. Comparator Application 15.3.1 Schmitt Trigger Circuits 3. Schmitt Triggers 15.3.1 Schmitt Trigger Circuits 3. Schmitt Triggers 15.3.1 Schmitt Trigger Circuits 4. Schmitt Triggers with VREF 15.3.1 Schmitt Trigger Circuits 5. Application 15.3.2 Square-Wave Generators 1. Schmitt Trigger Oscillator 15.3.2 Square-Wave Generators 2. Operating 15.3.2 Square-Wave Generators 3. Duty Cycle 15.3.3 Sawtooth-Wave Generator 1. Structure * 15.3.2 Square-wave Generators 15.3.3 Sawtooth-wave Generators Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Comparator compares two voltages one is input signal, other is reference voltage. It is similar to op-amp. When vI VREF , vO =VOH= +VCC ; vI VREF , vO =VOL= -VEE ; Saturation voltage of output T is negligible. It is a noninverting comparator. Inverting comparator It operates in an open-loop. No virtual short. Crossover voltage is defined as input voltage at which output changes states. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Voltage transfer characteristic Input is sine-wave signal, output is square-wave signal. When VREF =0,__ Zero-Crossing Detector. Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 1. Zero-crossing detector shown in fig. Sketch the voltage transfer characteristics. 2. If Input is sine-wave signal, what is output waveform? Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 3. If VREF is