[高职机械类专业英语.pptVIP

书名：机械类专业英语 ISBN： 9787111429326 作者：韩林烨 关雄飞 出版社：机械工业出版社 本书配有电子课件 Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Unit 3 Transmission of Gears 3.1 Introduction 3.2 Advantages and Disadvantages 3.3 Type of Gears 3.4 Gear Failures and Design Criteria Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. Gears are the most widely used method of transmitting power from one shaft to another or to a rack which translates in a straight line. Gears have the capacities of transmitting several ten thousand kilowatts (kW) of powers and rotating at 150 meters per second (m/s) of pitch-line speed. The maximum pitch-line speed that gears can achieve is approximately 300m/s. The maximum outside diameters may be made above 10 meters (m) and the maximum single transmission ratio may be above 8. Normally, the small gear of the two mating gears is called the pinion and the large one is referred to as the gear, regardless of which is the driver and which is the follower.1 When the pinion is on the driving shaft, the gear pair acts as a speed reducer; when the gear drives, the gear pair is a speed increaser. 3.1 Introduction Back→ Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 3.2 Advantages and Disadvantages of Gears 3.2.1 Advantages 3.2.2 Disadvantages high efficiency high reliability high service life constant transmission ratio compactness having a large range of power and speed transmitted. special machine tools are needed to manufacture the gears great quality class of gears is required they cost much the vibration and noise will occur when gears have low precisions gears cannot be used in the case of large center distance. Back→ Evaluation only. Created with Aspose.Slides for .NET 3.5 Client Profile 5.2.0.0. Copyright 2004-2011 Aspose Pty Ltd. 3.3 Type of Gear