14传动轴Driveshaft..docVIP

Drive shaft Page Notice PR-2 Troubleshooting PR-2 Diagrams PR-3 Disassembly and assembly PR-4 Technical requirement……………………… …...PR-10 Notice Notice: never clamp the drive shaft bushing too tight with a bench vise to protect from deformation. The drive shaft of this model is mainly applicable for the automotive of Qi Sheng series. Troubleshooting  Drive shaft Component diagram Drive shaft disassembly 1. Remove the drive shaft universal flange yoke from the differential flange. (1) Attach assembly mark to the two flanges. (2) Remove four pairs of nuts and bolts. 2. Disassemble the intermediate support bearing from the car chassis cross beam. 3. Remove the transmission from the drive shaft. (1) Pull out the transmission from the universal joint fork. (2) Insert a plug into the transmission to prevent oil leakage. Drive shaft disassembly 1. Attach assembly mark to the shaft and the universal join fork. 2. Remove the intermediate support bearing from the drive shaft front section of rear axle. (1) Loosen the riveted part of nuts with hammer and chisel. (2)Remove nuts. 3. Remove the universal joint from the drive shaft rear section of rear axle. (1) Attach assembly mark to the universal joint fork and the shaft. (2) Pull out the universal joint fork from the shaft. Inspection of drive shaft parts 1. Inspection of cross bearing Check the wearing or damage of the cross bearing and replace it if necessary. 2. Inspection of intermediate bea