Polycarbonatehasaglasstransitiontemperatureofabout147..doc

Polycarbonate has a glass transition temperature of about 147 °C (297?°F),[5] so it softens gradually above this point and flows above about 155 °C (311?°F).[6] Tools must be held at high temperatures, generally above 80 °C (176?°F) to make strain- and stress-free products. Low molecular mass grades are easier to mold than higher grades, but their strength is lower as a result. The toughest grades have the highest molecular mass, but are much more difficult to process. 聚碳酸酯的玻璃化转变温度约147℃下（297°F），[5]，所以它软化逐渐上面这点和流动高于约155°C（311°F），[6]工具必须保持在高温下，一般在80°C（176°F），以应变和应力产品。低分子量等级是比高年级更容易模制，但它们的强度是作为结果低。最艰难的等级最高的相对分子质量，但更难以处理。 Unlike most thermoplastics, polycarbonate can undergo large plastic deformations without cracking or breaking. As a result, it can be processed and formed at room temperature using sheet metal techniques, such as bending on a brake. Even for sharp angle bends with a tight radius, heating may not be necessary. This makes it valuable in prototyping applications where transparent or electrically non-conductive parts are needed, which cannot be made from sheet metal. Note that PMMA/Plexiglas, which is similar in appearance to polycarbonate, is brittle and cannot be bent at room temperature. 与大多数热塑性塑料，聚碳酸酯，可以承受较大的塑性变形，不开裂或断裂。其结果是，它可以被处理，形成在室温下利用金属片的技术，如制动器上的弯曲。即使是尖锐角的弯曲半径紧，加热可能没有必要。原型透明或者非导电性部件的应用中是需要的，它不能被由金属板制成的，这使得它具有很高的价值。请注意，聚甲基丙烯酸甲酯/有机玻璃，这是在外观上类似于聚碳酸酯，是脆的，并且不能在室温下弯曲。 Main transformation techniques for polycarbonate resins: extrusion into tubes, rods and other profiles including multiwall extrusion with cylinders (calenders) into sheets (0.5–20?mm (0.020–0.79?in)) and films (below 1?mm (0.039?in)), which can be used directly or manufactured into other shapes using thermoforming or secondary fabrication techniques, such as bending, drilling, routing, laser cutting etc. injection molding into ready articles 聚碳酸酯树脂的主要转换技术：????包括多层管，棒等型材挤压成????挤出与气缸（压延）成片（0.5-20毫米（0.020-0.79在））和薄膜（低于1毫米（0.039英寸）），可以直接使用或制造成其它形状，使用热成型或二次加工技术，例如作为弯曲，钻孔，路由，激光切割等。????准备物品的