无线电遥控系统设计论文..doc

吉林电子信息职业技术学院 毕业论文 题目：简易无线电遥控系统 专业： 学生姓名： 指导老师： 摘 要 本系统主要由单片机进行控制，发射部分通过单片机对信号进行编码输出，与晶体振荡电路产生的载波信号，共同作用到ASK调制器经谐振功率放大器，低通滤波器发射出去。接收部分，天线接收到信号经小信号放大器、解调器、解码器，把信号送到被控端，从而控制灯泡的亮度及LED的亮灭。 关键词：AT89C52单片机 晶体振荡电路 ASK Abstract This system mainly by the single-chip microcomputer control, partly through the monolithic integrated circuit to launch code, and the output signal of crystal oscillator circuit carrier signal, produced by the joint action of ASK modulator resonant power amplifier, low-pass filter launch out. Receiving part, the antenna to signal the small signal amplifiers, modem and decoder, accused the signals to the bulb, which control the bright brightness and LED them. Key words: AT89C52 single chip computer crystal oscillator circuit ASK 目 录 一、引言......................................................5 二、设计要求..................................................6 2.1、基本要求.......................................................6 2.2、发挥部分.......................................................6 方案设计..................................................7 3.1方案一...........................................................7 3.2方案二...........................................................8 系统设计与分析............................................9 4.1键盘编码解码.....................................................9 4.2调制与解调......................................................16 4.3功率放大器与天线..................................................14 4.4放大器..........................................................15 主要软件流程图...........................................16 系统功能与测试...........................................18 6.1、测试仪器与设备................................................18 6.2、指标测试......................................................18 七、小结....................................................19 八、总结体会.................................................20 九、附主要程序...............................................21 参考文献.