06学生介绍——程序的引导-中断系统Part4——InterruptSystemC28x摘要.ppt

* LOOP: Use in LOOPZ and LOOPNZ instructions. This bit is set when the instruction is still active. EALLOW: Emulation allow. This bit is set to allow retime debugger feature. IDLESTAT: Another bit use in emulation. * 4 - * Texas Instruments Incorporated European Customer Training Center University of Applied Sciences Zwickau (FH) Module 4 : Interrupt System C28x 32-Bit-Digital Signal Controller TMS320F2812 程序指针PC复位值（查CPU寄存器）？ PC如何由上电引导CPU到用户程序？ 如何进入实时中断程序？ 相关内容查CPU结构、存储器配置、中断机制等—F2812见第3、5章 TMS320F2812 Memory Map MO SARAM (1K) M1 SARAM (1K) LO SARAM (4K) L1 SARAM (4K) HO SARAM (8K) Boot ROM (4K) MP/MC=0 BROM vector (32) MP/MC=0 ENPIE=0 OTP (1K) FLASH (128K) reserved reserved reserved PF 0 (2K) reserved reserved PF 1 (4K) reserved PF 2 (4K) reserved PIE vector (256) ENPIE=1 XINT Zone 0 (8K) XINT Zone 1 (8K) XINT Zone 2 (0.5M) XINT Zone 6 (0.5M) XINT Zone 7 (16K) MP/MC=1 XINT Vector-RAM (32) MP/MC=1 ENPIE=0 reserved reserved reserved Data | Program 0x00 0000 0x00 0400 0x00 0800 0x00 0D00 0x00 1000 0x00 6000 0x00 7000 0x00 8000 0x00 9000 0x00 A000 0x3D 7800 0x3D 8000 0x3F 8000 0x3F A000 0x3F F000 0x3F FFC0 0x3F C000 0x18 0000 0x10 0000 0x08 0000 0x00 4000 0x00 2000 Data | Program 128-Bit Password reserved 0x3D 7C00 C28x Core Interrupt Lines C28x CORE 2 non-maskable 硬件复位或冷启动XDS，优先级是最高的，中断向量存在中断向量表的第一位置 NMI中断，处理系统重要请求 14 maskable interrupts (INT1 – INT14) 一般MCU只有一个中断向量表，而DSP有多个，见P120.复位在哪？ INT1 INT2 INT3 INT4 INT5 INT6 INT7 INT8 INT9 INT10 INT11 INT12 INT13 INT14 RS NMI Register Bits Initialized at Reset Register bits defined by reset PC 0x3F FFC0 PC loaded with reset vector ACC 0x0000 0000 Accumulator cleared XAR0 - XAR7 0x0000 0000 Auxiliary Registers DP 0x0000 Data Page pointer points to page 0 P 0x0000 0000 P register cleared XT 0x0000 0000 XT register cleared SP 0x0400 Stack Pointer to address 0400 RPC 0x00 0000 Return Program Counter cleared IFR 0x0000 no pending interrupts IER 0x0000 maskable interrupts disabled DBGIER 0x0000