大学学位论文--大型花样喷泉控制系统设计.docVIP

毕 业 设 计 [论 文] 题 目： 学 院： 电气与工程学院 专 业： 姓 名： 学 号： 指导老师： 完成时间： 摘要 该花样喷泉控制系统设计的是7-200 PLC软件，利用该软件对控制系统程序编写和仿真的主要目的是使喷泉喷水样式的多样化，所编写的程序使花样喷泉的运行规律化按下开始按钮使的喷水由花样和单步共同决定按下单步按钮时，喷泉就会按照一个花式运行一次，然后停止运行若选择的连续模式，喷泉就会在的花样下多次运行，直到按下停止按钮后，喷泉装置才停止运行喷泉的花样则可以通过选择开关来控制，本设计提供了不同水花样 Abstract The figure fountain control system design USES is Simon S7-200 PLC software, fountain control system to make use of the software programming and simulation. The main purpose of this design is to make the water fountain, style diversity, use written procedures to make pattern the operation law of the fountain. When press the start button, the device is up and running, when press the stop button, fountain control device will stop working immediately .Fountain of hydraulic way is by the fountain pattern mode selector switch and joint decision step/continuous switch: when step according to the order button, the fountain will be in accordance with the style of a flower run once, then stop running; If choose continuous mode, fountain will in advance under the selected pattern cycle for many times, until after the press the stop button, fountain device didnt stop running. Pattern of fountain operation pattern may be able to switch to control, this design provides four different ways of water pattern. Siemens S7-200 PLCs biggest feature is strong scalability, at the same time also has a good stability, high reliability, simple operation, etc. Fountain control system adopts PLC design pattern, meet the design requirements: automatically convert fountain water spray pattern. So the PLC can be widely in the industry. Key words: Figure fountain; S7-200 PLC; Automatic control 目录 摘要 I Abstract II 目录 III 第1章 绪论 1 1.1 课题背景 1 1.2课题