顆粒强度测定仪(500N中英文).docVIP

数显颗粒强度仪 使 用 说 明 书 ? 泰州市奥普特分析仪器有限公司 TaiZhou City AoPuTe Analysis Instruments Co. Ltd. ? ? ? First, an overview KC?—?3?—?500?Digital particle strength Tester using advanced measurement and control technology, can automatically complete the afterburner, measured display, maximum intensity value for the lock and reset operations, a high degree of automation, measuring a wide range of new instruments, the instrument has small size, measuring value is direct reading, the advantages of high accuracy, ease of use, is the ideal new instruments for determination of particle strength. 一、概述 KC—3—500型数显颗粒强度仪采用先进的测量控制技术，可自动完成加力、测量显示、最大强度值的锁定及复位等操作，是一种自动化程度较高、测量范围较宽的新型仪器，该仪器具有体积小、测量值直读、精度高、使用方便等优点，是颗粒强度测定理想的新型仪器。 Second, the main technical indicators?： 1.?power supply:AC220V±10% 40W 2.?ambient temperature: 0℃～40℃ 3.?relative humidity: ≤85% 4.?particle size: ≤25mm 5.?measuring range:5N~500N 6.?resolution:1N 7.?measuring accuracy: ≤0.5%FS 8.?overall dimension: 225mm×325mm×330mm 9.?weight:?10kg 二、主要技术指标： 1.电源电压：AC220V±10% 40W 2.环境温度：0℃～40℃ 3.相对湿度：≤85% 4.颗粒直径：≤25mm 5.测量范围：5N～500N 6.分辨率：1N 7.测量精度：≤0.5%FS 8.外型尺寸：225mm×325mm×330mm 9.重量： 10㎏ Third, the use of methods 1.?connect main power switch behind the instrument the display shows?000, such as too much deviation from the zero point, apply a screwdriver to fine-tune the zero button,?000?close by.?Front panel power supply for instrument power supply.?Start?/?reset a different status LEDs of different colors, when reset to the Red start light is green.?When the range is exceeded alarm indicator lights, instrument and buzzer beep. 2.?test doors open, central location places the samples samples, close the test window.?Press the start key, linear motor automatically Afterburner, access to sample, monitor real-time data output when samples during crushing, a loud buzzer short Tweet to make prompt, force the maximum number (strength) will be locked, and linear motor in reverse, until the reset stops. 3.?continue to experiment,