[XDM告警列表.docVIP

List of xdm alarms XDM告警列表 Written by Sunny 16-June-2004 Transmission Alarms 传输告警 Alarm name告警名称 Probable Cause可能的原因 LOS信号丢失 Indicates a significant drop in receive signal level can be caused by broken fiber , fiber cuts , disconnected fiber or faulty optical transmitter. 指示光接口或电接口的收端没有信号输入。产生原因：接口收端电缆线断了，2M/155M头不好，没上业务等；光缆断了，光接口对端没发光等。 LOD数据丢失 Loss of Data represents the case in which optical LOS is not being detected but no signal transitions exist. 光接口收不到信号但又检测不到LOS时产生此告警。例如光接口连到纯光源上时产生LOD。 LOP指针丢失 Invalid pointers are received due to equipment failure or mismatch in signal mapping or timing problems. 设备故障，信号映射失配或时钟问题。 LOF帧丢失 Indicates no detect of frame alignment in the incoming signal 接收的信号中没有监测到帧队列 AIS告警指示信号 Indicates upstream failure . indicates that another alarm exists previous to the equipment sending the AIS. 指示上游失败。指示另外一个告警，即上游那个发送AIS信号的设备存在的告警。 AU/TU AIS管理单元或时隙的告警指示信号 Indicates upstream failure . indicates that another alarm exists previous to the equipment sending the AIS. 指示上游失败。指示另外一个告警，即上游那个发送AIS信号的设备存在的告警。 SSF服务信号失败 Server signal failure . Indicates failure in adaptation function due to AU_AIS or AU_LOP. 服务信号失败。指示基于AU_AIS 或 AU_LOP的相应功能失败。. EXC误码率过高 The Bit Error Rate (BER) on the incoming signal frame is higher than a specific configured threshold. 接收信号帧误码率高于一个特定门限值 DEG信号劣化 The Bit Error Rate (BER) on the incoming frame is higher than a specific configured threshold. This threshold is lower than the one specified for EXC 接收信号帧误码率高于一个特定门限值。但这个门限值低于产生EXC的门限值。 RDI远端接收失败 Remote defect indication received , indicating far end signal fail condition . 远端接收失败，指示远端失败情况。 RAI远端接收失败 Remote defect indication received , indicating far end signal fail condition . 远端接收失败，指示远端失败情况。 TIM通道匹配缺失跟踪指示 Trace Identifier Mismatch defect caused by a misprovisioning of the expected trace or misconnection (The alarm is result of compare of the expected J0/J1/J2 byte to the received one) 通道匹配缺失跟踪指示。产生原因：通道属性期望值定义不正确，错误的连接（此告警是J0/J1/J2字节收