technicalspecificationforvariablefrequencydrives（9页）.docVIP

University Health System Technical Specifications For Variable Frequency Drives (VFD’s) In the 3 - 800 Horsepower range GENERAL The Variable Frequency Drive shall be a Clean Power voltage source, advanced Pulse-Width Modulated, space vector technology motor controller which utilizes the latest IGBT technology and surface mount construction to afford efficient use of available space, prudent energy consumption and reliability. The Variable Frequency Drive(s) shall not induce excessive power losses in the motor. Worst case Root Mean Square (RMS) motor line current measured at rated speed, torque and voltage shall not exceed 1.05 times the rated RMS motor current for pure sine wave operation. All Variable Frequency Drive(s) shall be supplied with an input AC line reactor of minimum 2.5% impedance. Input (AC) Line Reactor shall be designed to address performance issues of NEMA MG1-20.55 and to provide proper transient protection of the VFD input power devices. Input (AC) Line Reactor shall be factory mounted and wired within the VFD enclosure. The Variable Frequency Drive(s) shall operate satisfactorily when connected to a bus supplying other solid state power conversion equipment which may be causing up to 10% total harmonic voltage distortion and commutation notches up to 36,500 volt/microseconds, or when other VFD’s are operated from the same bus. Individual or simultaneous operation of the VFD’s shall not add more than 5% total harmonic voltage distortion to the normal bus, nor more than 10% while operating from standby generator bus, To meet or exceed IEEE 519, 1992. The Variable Frequency Drive shall maintain a displaced power factor of .95 or better, at all speeds without external correction capacitors, and shall have a continuous output current rating of 110% of nameplate current. Suitable Variable Frequency Drive(s) shall utilize advanced Pulse Width Modulation (PWM) strategy which can be of the space vector type, implemented within a microprocesso