本科毕设论文_脸盆注塑模具设计.docVIP

摘要 本文介绍了注射模具的特点及发展趋势，叙述了塑料塑料盆注射模具设计与计算的详细过程，介绍了该塑件成型工艺、注射模具的结构特点与工作过程, 阐述了在注射模设计中应注意的事项。注射模分型面侧抽芯脱模机构。abstract The characteristics and developments of injection mould were introduced in this paper. The designing and calculating of injection mould for the back of electronic clock were stated in detail. The forming process of the product and the structure characteristics as well as working process of the injection mould were introduced .The points must be paid attention to in the design of the injection mould for the part with lifters were stated. In the process of the designing of the injection mould for electronic clock receiver, people should pay attention to several suggestions: the plastic should be designed as reasonable as possible. The selection of the sub-type parts are beneficial? to mold the parts of plastic. The design of the? structure of drawing of pattern is not only simple but also the movement should be stable and reliable. The selection of Jin runner should ensure to fill the plastic equally under the prerequisite of not influencing the appearance of the plastic. The design of cooling penstock should make the rate of production reach to the topmost, and ensure any influence to do nothing to the equality of the plastic. Meanwhile, in the process of designing ,we can use analysis soft, such as CAM, to make the design been more reasonable? and efficient. Making full use of? large amounts of standard pieces will reduce the cost of mold plastic facture. The key point of the design of mold plastic have reached the request of the real production.? Keywords: Plastic?injection mould,?plastic basin,?the parting surface,?the side core pulling,?demoulding mechanism. 目录 摘要 1 abstract 2 目录 3 前 言 5 1.塑料模具的现状及展望 6 1.1模具工业在国民生产中的作用 6 1.2塑料模具工业的现状 6 1.3塑料模具工业的发展趋势 7 2.塑件的成型工艺分析 8 2.2 塑料盆材料的选用 8 2.3 产品的结构分析 8 2.4塑件的成型工艺参数 9 3.成型设备的选用 11 3.1确定注射成型的工艺参数 11 3.2确定模具温度及冷却方式 12 4.模具结构形式的确定 14 4.1确定型腔数目及排列方式 15 4.2注射模分型面的选择 15 4.2.1分型面的形式 16 4.2.2分型面