用路由器做的单臂路由,vlan,trunk.docVIP

单臂路由 如图.使用PC1，PC2，SW1，R1 PC1 pc1#enable pc1#configure t Enter configuration commands, one per line. End with CNTL/Z. pc1(config)#no ip routing pc1(config)#hostname pc1 pc1(config)#no ip domain-lookup pc1(config)#no ip routing pc1(config)#ip default-gateway 1.1.1.254 pc1(config)#line console 0 pc1(config-line)#logging sy pc1(config-line)#exit pc1(config)#interface fa0/0 pc1(config-if)#ip address 1.1.1.1 255.255.255.0 pc1(config-if)#no shutdown pc1(config-if)#exit pc1(config)#exit pc1# 00:03:32: %SYS-5-CONFIG_I: Configured from console by console pc1# 00:04:05: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not full duplex), with Router FastEthernet1/11 (full duplex). pc1# 00:05:04: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not full duplex), with Router FastEthernet1/11 (full duplex). pc1# 00:06:03: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not full duplex), with Router FastEthernet1/11 (full duplex). pc1# 00:07:02: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not full duplex), with sw1 FastEthernet1/11 (full duplex). pc1#show ip route Default gateway is 1.1.1.254 Host Gateway Last Use Total Uses Interface ICMP redirect cache is empty pc1# 00:08:01: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not full duplex), with sw1 FastEthernet1/11 (full duplex). pc1#ping 2.2.2.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 2.2.2.1, timeout is 2 seconds: ..!!! Success rate is 60 percent (3/5), round-trip min/avg/max = 56/81/104 ms pc1#ping 2.2.2.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 2.2.2.1, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 40/60/72 ms pc1# 00:09:00: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/0 (not full duplex), with sw1 FastEthernet1/11 (full duplex). PC2 Routerenable Router#conf