LoadPull---ADS(负载牵引详细介绍资料)解读.ppt

Andy HowardApplications Engineer28 May, 2002 Load Pull Simulation Using ADS Outline Overview Specifying and generating desired load reflection coefficients Assigning arbitrary reflection coefficients at the harmonic freqs. Biasing the device and running a simulation Calculating desired responses (delivered power, PAE, etc.) Generating contour lines Load pull simulation varies the load reflection coefficient presented to a device... …to find the optimal value to maximize power or PAE, etc. Specify the load reflection coefficients Sweeping rho over a circular region Use ReflectionCoefUtility data display to help set s11_center and s11_rho Two variables are swept to generate the points within the desired circle More on the swept variables Sweep limits for “imag_indexs11” What is “max_rho”? What about the “max_rho/(lines+1)” term? Sweep limits for “real_indexs11” How is c_limit calculated? How are the number of lines and the points per line calculated? Alternate reflection coefficient sweep Outline Overview Specifying and generating desired load reflection coefficients Assigning arbitrary reflection coefficients at the harmonic freqs. Biasing the device and running a simulation Calculating desired responses (delivered power, PAE, etc.) Generating contour lines You could make the load independent of frequency: Set source and load impedances at harmonic frequencies arbitrarily Defining a single, frequency-dependent reflection coefficient (1) Defining a single, frequency-dependent reflection coefficient (2) Defining a single, frequency-dependent reflection coefficient (2 continued) How is iload calculated? More details Load pull at a harmonic frequency Outline Overview Specifying and generating desired load reflection coefficients Assigning arbitrary reflection coefficients at the harmonic freqs. Biasing the device and running a simulation Calculating desired responses (delivered power, PAE, etc.) Generating contour lines Modify the bias network as desired Outline