交换机STP配置.docVIP

交换机STP配置 功能需求及组网说明 STP配置 『配置环境参数』 交换机SwitchA和SwitchB通过E1/0/23和E1/0/24接口互连； pcA通过E1/0/1和SwitchA互连；pcB通过E1/0/1和SwitchB互连。 『组网需求』 要求整个网络运行STP协议。 数据配置步骤 【SwitchA交换机配置】 启动生成树协议 [SwitchA]stp mode stp [SwitchA]stp enable %Apr 2 03:59:14:016 2000 switchA MSTP/3/STPSTART:- 1 -STP is now enabled on the device. 【SwitchB交换机配置】 启动生成树协议 [SwitchB]stp mode stp [SwitchB]stp enable %Apr 2 03:59:14:016 2000 switchA MSTP/3/STPSTART:- 1 -STP is now enabled on the device. 【查看SwitchA的Ethernet 1/0/1的stp状态：】 [switchA]display stp interface Ethernet 1/0/1 ----[CIST][Port1(Ethernet1/0/1)][FORWARDING]---- Port Protocol :enabled Port Role :CIST Root Port Port Priority :128 Port Cost(Legacy) :Config=auto / Active=200 Desg. Bridge/Port :32768.000f-e2b7-5711 / 128.1 Port Edged :Config=disabled / Active=disabled Point-to-point :Config=auto / Active=true Transmit Limit :10 packets/hello-time Protection Type :None MSTP BPDU format :Config=auto / Active=legacy Port Config Digest Snooping :disabled Num of Vlans Mapped :1 PortTimes :Hello 2s MaxAge 20s FwDly 15s MsgAge 0s RemHop 0 BPDU Sent :2 TCN: 1, Config: 1, RST: 0, MST: 0 BPDU Received :122 TCN: 0, Config: 122, RST: 0, MST: 0 【查看SwitchA的Ethernet 1/0/2的stp状态：】 [switchA]display stp interface Ethernet 1/0/2 ----[CIST][Port2(Ethernet1/0/2)][DISCARDING]---- Port Protocol :enabled Port Role :CIST Alternate Port Port Priority :128 Port Cost(Legacy) :Config=auto / Active=200 Desg. Bridge/Port :32768.000f-e2b7-5711 / 128.2 Port Edged :Config=disabled / Active=disabled Point-to-point :Config=auto / Active=true Transmit Limit :10 packets/hello-time Protection Type :None MSTP BPDU format :Config=auto / Active=legacy Port Config Digest S