科研论文范文：王振成-长细波纹管伸缩接头以梁式模型的变形分析.docVIP

·研究简报· 长细波纹管伸缩接头以梁式模型的变形分析* 王振成 刘爱荣2 程冬梅 魏金营 高明宪（1. 中州大学 工程技术学院郑州 4500442. 中州大学 信息工程学院郑州 450044 （3. 郑州市公共交通总公司郑州 450054） 对薄壳的几何参数和壳两端固定位移的比率几乎相差无几，而且理论计算结果与实验数据非常接近。 关键词 波纹管 伸缩接头 薄壳模型 典型方程 逐次逼近 折线硬化 积分塑性函数 中图分类号 TH114 Distortion Analysis About Long and Thin Bellows Expansion Joints WANG ZhenCheng1 LIU AiRon2 CHENG DongMei1 WEI JinYing3 GAO MingXian3 (1. College of Technology Engineering, Zhongzhou University, Zhengzhou 450044, China) (2. College of Information Engineering, Zhongzhou University, Zhengzhou 450044, China) (3. Zhengzhou General Corporation of Public Communication, Zhengzhou 450054, China) Abstract A fixed end beam model was established to the long and thin bellows expansion joints（）and the typical equation under elastic deflection or plastic deformation was also listed. According to the assumed boundary conditions of the bellows both ends, the working environment of cyclic fatigue and the actual situations of the materials of its broken line hardening, approximating solution could be obtained by successive integral solution to the mentioned typical equation in line with requirement of the accuracy through the computer. The conclusion was closed to the result of the axis symmetrical shell model. That was non-dimensional relationship was almost the same to the geometric parameters of the shell and the ratio of fixed displacement of its both ends and the theoretical calculation results were very closed to the experimental data. Key words Bellows; Expansion joints; Shell model; Typical equation; Approaching gradually; Broken line hardening; Integral plastic function Corresponding author: WANG ZhenCheng, E-mail: zzwzc@163.com zgdxlar@ Manuscript received in revised form 到初稿,到修改稿。 0371宅）手机)王振成, 男, 19592月生, 河南项城市人，汉族副教授，高级工程师，长期从事机械工程设计及理论的实践、教学和研究，曾任焦作市金属镁冶炼厂长兼总工程师发表论文二十余篇，现在中州大学从事教学工作：郑州市惠济区英才街6号中州大学工程技术学院引言工