instruction manual- d a l e600600 e（说明书- d l e600600 e）.docVIP

Instruction Manual - DALE600/600E WARNING TO ENSURE TOTAL SAFETY TO THE PATIENT, DISCONNECT ALL PATIENT CONNECTIONS TO THE DEVICE TO BE TESTED BEFORE STARTING It is best to start from the same position each time. Place the analyzers switches in the following initial positions: ????Neutral Switch CLOSED ????Polarity Switch OFF (center) Plug the DALE600/600E into an outlet properly rated. The analyzer is equipped with a hospital-grade power plug. Grounding reliability can only be achieved when the analyzer is connected to an equivalent power receptacle marked Hospital-Grade. Grounding is important for personnel safety and to make some of the tests offered by the analyzer. Do not circumvent for any reason. The three (9) neon lights should provide indication of the polarity and condition of the outlet used. ~ ~ ~??? USING THE ANALYZER VERIFYING THE POWER OUTLET CONNECTIONS Note: Not applicable to isolated power systems Three neon lamps provide indication of the polarity and condition of the outlet being used as determined by the follwoing chart: Note: Does not check Open Neutral or Neutral/Ground reversed MEASURING THE LINE VOLTAGE From the recommended starting position, set the FUNCTION (7) switch in LINE VOLTS position. The digital display (8) will display the line voltage with a resolution of one (1) volt. Switching the POLARITY (4) switch to the NORMAL position and turning on the DUT, the meter display will continue to read line voltage but under the load of the device being tested. MEASURING THE DEVICES CURRENT Switch the FUNCTION (7) switch to CURRENT. The meter will display the devices current to 19.99 Amperes. The POLARITY (4) switch must be in the NORMAL, the NEUTRAL (3) switch in the CLOSED position. Turn the DUT on, and place it in its maximum load condition to obtain proper reading. MEASURING THE CHASSIS GROUNDING RESISTANCE This test is only applicable to devices utilizing three wire (grounded) power cords. Conn