oil filledand wire wound instrument transformer standards（石油filledand线绕式仪表变压器标准）.docVIP

EXHIBIT B PRELIMINARY ISO SPECIFICATION No. IT - 001 FOR MANUFACTURER CERTIFICATION OF OIL-FILLED, WOUND INSTRUMENT TRANSFORMERS FOR REVENUE METERING. PREPARED FOR METER SUB-TEAM, ISO December 18, 1996 TABLE OF CONTENTS 1.0 PURPOSE 2.0 SCOPE 3.0 REFERENCES 4.0 DEFINITIONS 5.0 SPECIFICATION 5.1 General 5.2 Current Transformers (CT) 5.3 Voltage Transformers (VT) 5.4 Combination Current/Voltage Transformers (CT/VT) 5.5 Grounding 5.6 Primary Terminals 5.7 Paint and Finish 5.8 Porcelain 5.9 Insulating Oil 5.10 Accessories 6.0 TESTING 7.0 REQUIRED INFORMATION 1.0 PURPOSE To specify the technical requirements for manufacture and supply of reliable high-accuracy Current and Voltage Transformers to be used for Revenue Metering on the ISO Transmission Grid. 2.0 SCOPE 2.1 Oil-filled Single-Phase Current Transformer - 35kV-230kV. 2.2 Oil-filled Single-Phase Voltage Transformer - 35kV-230kV. 2.3 Oil-filled Single-Phase Combination Current/Voltage Transformer - 35kV-230kV. 2.4 This Specification applies only to Oil-filled Wound Devices. Voltage Transformers 35kv are TYPE ACCEPTED devices. Voltage Transformers 230kv are to be individually specified in conjunction with Engineered Installations. . 3.0 REFERENCES All instrument transformers furnished under this specification shall be designed, manufactured, tested and supplied in accordance with the latest applicable standards of the National Electrical Manufacturers Association (NEMA) and the American National Standards Institute (ANSI), especially those listed below, with exceptions as may be contained in these Specifications ANSI C57.13IEEE Standard Requirements for Instrument Transformers. NEMA 107 Methods of Measurement of Radio Influence Voltage (RIV