ccna第九章练习答案.docVIP

1. What is the primary responsibility of the transport layer? allows access to the network media provides data representation and encoding selects paths through the network for data to travel defines end-to-end connectivity between host applications 窗体顶端 2. Why is IP considered a best-effort protocol? IP detects lost packets. IP validates the content of the packets. IP does not provide acknowledgment of the data delivery. IP reorders the packet as they arrive at the destination host. 窗体顶端 3. Which IPv4 class of addresses provides the most networks? Class A Class B Class C Class D Class E 窗体底端 窗体顶端 4. Which IPv4 class provides the highest number of host addresses per network? Class A Class B Class C Class D Class E 窗体底端  窗体顶端 5. Which two statements correctly describe the IP address 127.0.0.1? (Choose two.) It belongs to the Class A range of addresses. It belongs to the Class B range of addresses. It belongs to the Class C range of addresses. It is reserved for loopback testing. It is reserved for multicast group testing. It is reserved for unicast testing. 窗体顶端 窗体底端 窗体底端 6. Refer to the exhibit. The small office LAN shown in the exhibit may eventually be connected to the Internet. According to Cisco best practice, which IP network addresses should be used? 12.0.0.0 172.0.0.0 172.168.0.0 192.32.17.0 192.168.67.0 225.1.5.0 窗体顶端 7. Why were private IP addresses developed? to permit dynamic assignment of IP addresses to permit the duplication of public IP addresses to minimize the utilization of reserved IP addresses to permit public IP addresses to be used in private networks to address the issue of not enough available public IP addresses 窗体底端 8. Which statement accurately describes public IP addresses? Public addresses cannot be used within a private network. Public IP addresses must be unique across