网络专业实验任务.pptVIP

* ? 交换机6509的一个vlan接口地址是这样配置的 interface?Vlan2ip?address?? ip?access-group?101?in ip?access-group?101?ou tip?route-cache?flow standby?ip? standby?priority?110 standby?preempt standby?track?GigabitEthernet1/47?50 ? HSRP:Hot?Standby?Routing?Protocol 2台设备虚拟一个地址，条件是系统中有多台设备，它们组成一个“hsrp组”，这个组有一个虚拟地址。正常情况下只有一个设备是active状态的，由它来转发数据包，如果active设备坏掉，将选择一个standby设备来替代成为active，选择条件就是其hsrp优先级大小 ?standby?[group ] ip???2台启用hsrp的交换机共用的虚拟地址 Standby [group] timer 5 50定义150组5秒交换一次hello信息,15秒没收到?hello信息就开切换 standby?[group] priority?110??设置该交换机hsrp优先级110，默认100， 越高越优先standby?[group] preempt??开启hsrp抢占，就是谁优先级高谁当active交换机 standby?[group] track?GigabitEthernet1/47?50??定义监控接口，track一个接口， 当接口g1/47?down掉，减去该交换机的hsrp优先级50，即为110-50=60，如果另外一台设备也开启了抢占，那么另外一台变成active交换机！ * * Step 5 Create a static route a. Create a static route from the ISP to the Gateway router. Addresses 2/27 have been allocated for Internet access outside of the company. Use the ip route command to create the static route. ISP(config)#ip route 2 24 8 Step 6 Create a default route a. Add a default route, using the ip route command, from the Gateway router to the ISP router. This will forward any unknown destination address traffic to the ISP. Gateway(config)#ip route 7 Step 7 Define the pool of usable public IP addresses To define the pool of public addresses, use the ip nat pool command: Gateway(config)#ip nat pool public-access 0 2 netmask 24 Step 8 Define an access list that will match the inside private IP addresses To define the access list to match the inside private addresses, use the access list command: Gateway(config)#access-list 1 permit 55 Step 9 Define the NAT translation from inside list to outside pool To define the NAT translation, use the ip nat inside source command: Gateway(config)#ip nat inside source list 1 pool public-access Step 10 Specify the interfaces The active interfaces on the router, need to be specified as either inside or outside interfaces with respect to NAT. To