Ansys_12.0_CFX_官方教程_15A.pptVIP

* Review and Tips 15-* ANSYS, Inc. Proprietary ? 2009 ANSYS, Inc. All rights reserved. April 28, 2009 Inventory #002598 Training Manual 15-* ANSYS, Inc. Proprietary ? 2009 ANSYS, Inc. All rights reserved. April 28, 2009 Inventory #002598 Chapter 15Review and Tips Introduction to CFX  鹃励灯露远成虫胜妈钾紫泡饲潭莽杂矾灌梢棉活乞声蛆蔚斧里溜龟逛说勿Ansys_12.0_CFX_官方教程_15AAnsys_12.0_CFX_官方教程_15A Domain Interfaces Domain Interfaces can be used as part of a meshing strategy as well as for connecting different domains or reference frames together Boundary conditions are created in each domain when a Domain Interface is created; generally you should not edit these directly When the mesh is different on each side of the interface a GGI (General Grid Interface) is used This will use more memory in the Solver than a continuous mesh Accuracy across a GGI interface is usually not a concern as long as the mesh length scales on each side are similar Automatic Domain Interfaces are created by CFX-Pre in some cases Always check these and don’t assume that all the required Domain Interfaces have been created 贾葫凝厉恨及粥足谚鹿异戳膛榴婚枝蹭屁溯岭泻宴暮以舷峪蜗中刘脯耪上Ansys_12.0_CFX_官方教程_15AAnsys_12.0_CFX_官方教程_15A Sources Sources are used to account for physics or processes that have not been directly resolved in the simulation Momentum sources can be used to create a pressure drop (e.g. a screen, a porous material) or a pressure rise (e.g. a fan) Energy sources can account for heat added/removed from the simulation When sources are functions of the solved variable (e.g. momentum sources that are functions of velocity, energy sources that are functions of temperature) the Source Coefficient should be set The Source Coefficient must be negative otherwise the solver will diverge May need to re-write the Source so that is has a negative derivative 坦掣钓脖歼霖帜阉聂搽樱蛔亭呻谰汗闪惫粉馏龄醛材僻查容灭揉盅抹汉巍Ansys_12.0_CFX_官方教程_15AAnsys_12.0_CFX_官方教程_15A Transient Simulations In a transient analysis the timestep should be small enough to capture the transient beh