实验13路由器广域网PPP封装PAP验证配置.docVIP

路由器广域网PPP封装PAP验证配置 一、实验目的 掌握PAP验证配置 理解验证过程 二、应用环境 基于安全的考虑，需要路由器双方经过验证后才能建立连接 三、实验设备 DCR-1702 两台 CR-V35MT 一条 CR-V35FC 一条 四、实验拓扑 五、实验要求 Router-A Router-B 接口 IP地址 接口 IP地址 S1/1 DCE 192.168.1.1 S1/0 DTE 192.168.1.2 帐号 密码 帐号 密码 RouterA digitalchinaA RouterB digitalchinaB 六、实验步骤 第一步 Router-A的配置 Routerenable ！进入特权模式 Router #config ！进入全局配置模式 Router _config#hostname Router-A ！修改机器名 Router _config# aaa authentication ppp test local Router-A_config#username RouterB password digitallchinaB ！设置帐号密码 Router-A_config#interface s0/2 ！进入接口模式 Router-A_config_s1/1#ip address 192.168.1.1 255.255.255.0 ！配置IP地址 Router-A_config_s1/1#encapsulation PPP ！封装PPP协议 Router-A_config_s1/1#ppp authentication pap test ！设置验证方式 Router-A_config_s1/1#ppp pap sent-username Router-A password digitalchinaA ！设置发送给对方验证的帐号密码 Router-A_config_s1/1#physical-layer speed 64000 ！配置DCE时钟频率 Router-A_config_s1/1#no shutdown Router-A_config_s1/1#^Z ！按ctrl + z进入特权模式 第二步：查看配置 Router-A#show interface s1/1 ！查看接口状态 Serial1/1 is up, line protocol is down ！对端没有配置，所以协议是DOWN Mode=Sync DCE Speed=64000 ！查看DCE DTR=UP,DSR=UP,RTS=UP,CTS=DOWN,DCD=UP Interface address is 192.168.1.1/24 ！查看IP地址 MTU 1500 bytes, BW 64 kbit, DLY 2000 usec Encapsulation prototol PPP, link check interval is 10 sec ！查看封装协议 Octets Received0, Octets Sent 0 Frames Received 0, Frames Sent 0, Link-check Frames Received0 Link-check Frames Sent 89, LoopBack times 0 Frames Discarded 0, Unknown Protocols Frames Received 0, Sent failuile 0 Link-check Timeout 0, Queue Error 0, Link Error 0, 60 second input rate 0 bits/sec, 0 packets/sec! 60 second output rate 0 bits/sec, 0 packets/sec! 0 packets input, 0 bytes, 8 unused_rx, 0 no buffer 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 8 packets output, 192 bytes, 0 unused_tx, 0 underruns error: 0 clock, 0 grace PowerQU