Training Stimulator Module培训教程文件.pptVIP

Life-Tech, Inc  Distributor Regional Block Training Manual EZStim Display Display A-Pause - Two dashes (ll) displayed before the current output reading indicates the instrument is in Pause. While in Pause mode the instrument does not function. Press Pause button to resume function. B-Current output- displays in 1 mA increments in 0-80 high output mode and .1 mA increments in .05-5 mA low output mode. C-Range-Displays 80 mA when the Red/Black (NSL-5) output leads are attached. Displays 5 mA when Gray/Black (RBW-5L) lead set is attached. D-Battery Indicator-Fully charged battery all black bars are displayed. E-Frequency-Display as Hz indicates how many stimulus pulses are delivered in one second F-Pulse width-Duration of the pulse or how long each pulse last. In high output the default is 0.2 milliseconds. In low output it is 0.1 milliseconds. G-Stimulus Pattern-Figure 3.3 shows all of the available patterns. Only Twitch in either 1 or 2 Hz is used for regional block. All other patterns are used during neuromuscular monitoring of muscle relaxants in the OR. These modes will not be active while in the low output setting. EZstim, Model ES400 Display  EZStim Front Panel Function Knob- Clockwise rotation increases current output. Counter clockwise rotation decreases output. Top Row Function Switches I/O-Power-Press to turn on or ff. Pause-Press to pause all functions. Press again to resume function. Speaker-Audio volume control-Press top speaker button to increase and bottom speaker to decrease. Defaults to mid rang setting upon power up. Can not be changed while in pause. Bottom Row Function Switches-Used for Neuromuscular Function monitoring in the OR (left-right) Train of Four- 4 pulses @ one half second apart. Repeats every 10 seconds automatically Double Burst-3 50 Hz pulses repeating automatically every 10 seconds.Used to determine recovery rate from muscle relaxants. 50 Hz Tetanus- 50 pulses per seconds. Response displayed as a complete mu