七台河精煤集团公司龙湖四矿0.9Mta新井设计.doc

摘 要 该设计矿井为七台河精煤集团责任有限公司龙湖四矿的新井设计，设计生产能力为0.90Mt/a，服务年限75a。井田共划分为2个水平开采，井田内有7层可采煤层，分别为54A#、55#、56#、57上#、57#、58上#、58#。井田平均走向长2600m，平均倾斜长5000m，煤层总厚度为14.4m。平均厚度为2.0m。工业储量为144.8Mt。根据地质资料该煤层平均倾角为13°，属缓倾斜煤层。 由于井田倾斜长度较大，且为缓倾斜煤层，以及煤层地质条件等因素影响，决定本井田内部分采用倾斜长壁采煤法开采,工作面全部为综合机械化采煤。本设计矿井采用双斜井和集中大巷布置方式。主井采用胶带输送机运输，副井采用人车和矿车运输。主运输石门采用3t底卸式矿车运输。井底车场采用卧式车场形式。矿井通风采用抽出式通风方式。 关键词 可采储量 采煤工艺 倾斜开采 Abstract This design mine is designed for the longhu fouth newly-built mine of the Qitaihe float coal Co.Ltd. The capacity of which is 0.90Mt/a, The service life of which is 75a. The well field is divided into two horizon exploition of which there are seven coal seams. There are 54A#、55#、56#、57#up、57#、58#up、58#. The average trend is 2600m of the well field. The average declivity length is 5000m. The total thickness is 14.4m. The average thickness is 2.0m.The industry storage capacity is 144.8 Mt.The average ralze angle of coal seams is 13°according to the geology data. It belongs to gently inclined coal bed . Because the declivity length of the mine is too long and belongs to gently inclined coal bed and is effected by geological conditions. The mine well should be exploited by the way of declivity longwall workface. The workface is totally comprehensive mechanized coal mining method. The mine is designed by the way of double incline opening and center tunnel. The main shaft is conveyed by rubber belt conveyer. The auxiliary shaft is conveyed by the carrying-man-bogie and bogie. The main haulage cross-cut is lonveyed by 3t hopper bogie. The shaft station is in the form of horizontal yard. The air draught is in the form of exhaust ventilation. Key words: recoverable reserves coal technolog declivity exploition 目 录 摘 要 I Abstract II 目 录 III 绪 论 VII 第1章 井田概况及地质特征 1 1.1 井田概况 1 1.2 地质特征 2 1.2.1矿区范围内地层情况 2 1.2.2井田范围内和附近的主要地质构造 3 1.2.3煤层赋存状况及可采煤层特征 4 1.2.4岩石性质 厚度特征 5 1.2.5井田内的水文地质情况 5 1.2.6瓦斯 煤尘爆炸性及煤的自然性 5 1.2.7煤质 牌号及用途 5 1.3 地质勘探程度及可靠性 6 第2章 井田境界 储量 服务年限 7 2.1 井田境界 7 2.1.1井田