应用小波转换及人工智慧进行配电系统电容切换暂态位置之判断.docVIP

超級電容運用在馬達剎車回升能量緩衝之研究 Design an energy buffer with super capacitors for motor brake application 蔡明村 朱慶隆 朱振源 蔡孟哲 Ming-Tsun Tsai Ching-Lung Chu Jhen-Yuan Jhu Meng-Che Tsai 南台科技大學電機工程系 Department of Electrical Engineering, Southern Taiwan University of Science and Technology Ma320115@stust.edu.tw 摘要 本文主要研製。:超級電容、馬達剎車、回生能量 Abstract A buffer device uses super capacitor energy storage element as a pick-up to be used in motor brake energy recovery. General CNC machining equipment will use a spindle motor. The spindle motor is controlled by the traditional V / F control of the inverter, its disadvantage is slow acceleration and deceleration, the conversion speed longer. If the spindle servo motor with inverter control, at the time of tapping speed can immediately convert, tapping time can be shortened, increasing the production rate. If the spindle motor is driven by servo control, you can switch immediately when it is tapping. It can be shortened and increase production speed at the same time. When the motor when accelerating, energy is converted to kinetic energy, but in the kinetic energy into electrical energy during deceleration. If you shorten the time switching speed, which can cause instant energy recovery in the internal capacitor voltage has risen sharply. Even more than the upper limit of the maximum voltage capacitor capacitance and cause damage. It should be used with appropriate energy release device and release this energy. It can also be recycled back to the power supply system to improve the energy re-use efficiency. In this study, the development of this energy in the buffer and recovery, which uses super capacitor to store electrical energy, and improve communication with the AC adapter to DC converter caused DC switching and conduction losses. In this paper, we use non-isolated bidirectional DC / DC converter interposed between the DC bus between the super capacitor. DC bus ceiling set in 400V, super capacitor upper limit set at 200V, we can