实现存储器EEPROM_AT24C02的数据读写操作_采用IIC总线读写_C程序.docVIP

/*************************************************************** ***************************************************************/ #include INTRINS.H #include reg52.h #define WriteDeviceAddress 0xa0 //写驱动地址指令 #define ReadDeviceAddress 0xa1 //读驱动地址指令 sbit AT24C02_SCL = 0xa4; sbit AT24C02_SDA = 0xa5; /* 功能：发起始信号 */ void Start_Cond() { AT24C02_SCL = 0; _nop_(); AT24C02_SDA = 1; _nop_(); AT24C02_SCL = 1; _nop_(); AT24C02_SDA = 0; _nop_(); } /* 功能：发停止信号 */ void Stop_Cond() { AT24C02_SCL = 0; _nop_(); AT24C02_SDA = 0; _nop_(); AT24C02_SCL = 1; _nop_(); AT24C02_SDA = 1; _nop_(); } /* 功能：发确认信号 */ void Ack() { AT24C02_SCL = 0; _nop_(); AT24C02_SDA = 0; AT24C02_SCL = 1; _nop_(); AT24C02_SCL = 0; _nop_(); AT24C02_SDA = 1; } /* 功能：发无确认信号 */ void NoAck() { AT24C02_SCL = 0; _nop_(); AT24C02_SDA = 1; _nop_(); AT24C02_SCL = 1; _nop_(); AT24C02_SCL = 0; _nop_(); } /* 功能：写一个字节数据 */ bit Write8Bit(unsigned char input) { unsigned char i; for (i=0;i8;i++) { AT24C02_SCL = 0; input = 1; AT24C02_SDA = CY; AT24C02_SCL = 1; } AT24C02_SCL = 0; _nop_(); AT24C02_SDA = 1; AT24C02_SCL = 1; _nop_(); CY = AT24C02_SDA; return(CY) ; } /* 功能：读一个字节数据 */ unsigned char Read8Bit() { unsigned char temp,rbyte=0; for (temp = 8;temp != 0;temp--) { AT24C02_SCL = 0; _nop_(); rbyte = (rbyte 1) | AT24C02_SDA; AT24C02_SCL = 1; _nop_(); } return rbyte; } /* 功能：从EEPROM中给定一个地址连续读NLEN个字节数据存放在以指针 nContent开头的往下内容。 */ bit Read_Flash ( unsigned char *nContent, unsigned char nAddr, unsigned char nLen ) { unsigned char Addr; Addr = nAddr; Start_Cond(); //写开始信号 Write8Bit(WriteDeviceAddress); //写驱动地址 Write8Bit(Addr); //写从EEPROM中读的开始地址 Start_Cond(); //写开始信号 Write8Bit(ReadDeviceAddress); //写读数据指令 while(--nLen) { *nContent=Read8Bit(); //读出内容 nContent++; //指针加1 Ack(); //发确认信号 } *nContent=Read8Bit(); //读一字节 NoAck(); //没有确认信号 Stop_Cond(); //发停止信号 return(0);