ABAQUS用户子程序.docVIP

ABAQUS用户子程序 ABAQUS/Standard subroutines： 1.CREEP: Define time-dependent, viscoplastic behavior (creep and swelling). 定义和时间相关的、粘塑性的运动（蠕变和膨胀） 2. DFLOW: Define nonuniform pore fluid velocity in a consolidation analysis. 在压实分析中，定义非均匀孔隙流速度 3. DFLUX: Define nonuniform distributed flux in a heat transfer or mass diffusion analysis. 在热传递和质量扩散分析中，定义非均匀的分布流量 4. DISP: Specify prescribed boundary conditions. 指定规定的边界条件 5. DLOAD: Specify nonuniform distributed loads. 指定非均匀的分布荷载 6. FILM: Define nonuniform film coefficient and associated sink temperatures for heat transfer analysis. 对热传递分析指定非均匀的膜层散热系数和联合的散热器温度 7. FLOW: Define nonuniform seepage coefficient and associated sink pore pressure for consolidation analysis. 对压实分析定义非均匀的渗流系数和渗入孔隙压力 8. FRIC: Define frictional behavior for contact surfaces. 对接触面定义摩擦 9. GAPCON: Define conductance between contact surfaces or nodes in a fully coupled temperature-displacement analysis or pure heat transfer analysis. 在一个完全耦合的温度—置换分析或者是纯热传递分析中，定义接触面或节点间的导热系数。 10. GAPELECTR: Define electrical conductance between surfaces in a coupled thermal-electrical analysis. 在耦合热电分析中，定义表面间的导电系数 11. HARDINI: Define initial equivalent plastic strain and initial backstress tensor. 定义初始等效应变和初始反应力张量 12. HETVAL: Provide internal heat generation in heat transfer analysis. 在热传递分析中提供初始热 13. MPC: Define multi-point constraints. 定义多点约束 14. ORIENT: Provide an orientation for defining local material directions or local directions for kinematic coupling constraints or local rigid body directions for inertia relief. 为定义局部材料方向提供定位；运动学耦合约束的局部方向；惯性释放的局部刚体方向。 15. RSURFU: Define a rigid surface. 定义一个刚性面 16. SDVINI: Define initial solution-dependent state variable fields. 定义初始和结果相关的变量场 17. SIGINI: Define an in