BEU台塔架设施工方案.docVIP

目 录 Content 1 工程概况General………………………………………………………………………1 2 施工依据 References……………………………………………………………………1 3施工程序 Construction Procedures……………………………………………………1 4施工技术要求 Construction Technical Requirements……………………………………2 5 HSE措施 HSE Measures …………………………………………………………………6 工程概况 General 此方案用于2PH装置塔和罐设备（以C4440、C3070为例）脚手架搭设，脚手架用来进行平台爬梯安装、设备保温、管线安装防腐保温。 This method statement is prepared for the scaffolding erection for the platform ladder installation, equipment insulation and anti-corrosion insulation of pipe lines for the towers and tanks (for example, C4440 and C3070) in 2PH. 编制依据 References: 《扣件式钢管脚手架搭设要求与设计计算》JGJ 130-2001 Erection Requirements and Design Calculation for the Steel Tubular Scaffold with Fastener JGJ 130-2001 《石油化工企业施工安全技术规程》SH3505-1999 Safety Technical Regulations for Petrochemical Construction SH3505-1999 施工程序 Construction Procedures 施工技术要求 Construction Technical Requirements 地面处理 Ground Preparation 在搭设架设前，对地面进行夯实，加大地面土质的密实度，增强地面的承重力；并应在松软地面上加放道木或钢板，确保架设地面承重力。地面夯实时，靠近基础的地面须高于外侧地面，防止下雨时因积水造成地面洼陷，影响整个架设的稳定性。 Prior to scaffolding erection, compact the ground to densify the soil and strengthen the bearing capacity of the ground. Besides, lay wood pillows or steel plates on the soft ground to ensure the bearing capacity to erect scaffolding. When compacting, the ground close to the foundation should be higher than that outside, to prevent the stagnant rainwater making the ground sunken and impacting the erection stability. 架设前放置立杆底座板，立杆插放在底座板上，增大立杆的受力面积，增强架设的稳定性。 Before erection, put the jack base under the rickers to increase the force area of rickers and strengthen the erection stability. 架设用材料选用须符合下列要求： The scaffolding materials should comply with the following requirements: 架杆选用φ48mm，壁厚3.5mm的钢制管道，材质符合GB7008-79对Q-235A钢的要求。 Use the steel tubes φ48mm with 3.5mm thic