Water jet correction.docVIP

Water jet correction: shaft sinking slowly on the side of the caisson external injection pressure of water around the outer wall, and make its soil mud, to reduce the resistance of soil. When rectifying to close to the normal position to stop water jet, and the open caisson with sand filling the gap between soil and the outer wall. Wells caused by edge foot side is stopped by the barrier, with conduit of shot hole is dug in below the boulder, charging will boulder crushing. Resulting from the well abandon or pile soil, take will well abandon or pile soil removal. After the completion of the open caisson sinking allowable deviation Projects allow deviation Edge foot deviation of average height and design elevation 100 mm Edge foot horizontal axis deviation 1/100 h (mm) Blade in any of the four corners of the foot two feet ground elevation difference Angle blade 1/100 b and 300 mm or less 8.3.5.6 open caisson bottom sealing When the open caisson sinking to the design elevation, after 8 hours accumulated subsidence observation is not more than 10 mm, which should be open caisson bottom sealing process. This project open caisson adopts undrained back cover (underwater concrete bottom sealing). Back before, will base the content such as mud, sediment was removed. The underwater concrete bottom sealing, underwater concrete, concrete pipe is commonly used in construction. Catheter for steel flange can be connected with the short tube, flange spool each section 1.0 m long, 300 mm in diameter. Before pouring underwater bottom sealing concrete, concrete pipe according to the preset position accurately placed in open caisson. Catheter bottom subsoil based distance from well than the ball plug big 5-10 cm in diameter. Catheter effective radius is 3 m or so commonly, its decorate all pipe casting area covered each other, the corner or the blanks can be added a catheter. With lead wire in intraductal capture put the ball slightly smaller than the tube diameter, plug (