OperationalAmplifiers毕业论文外文文献翻译及原文.doc

毕 业 设 计（论文） 外 文 文 献 翻 译 文献、资料中文题目：运算放大器文献、资料英文题目：Operational Amplifiers 文献、资料来源： 文献、资料发表（出版）日期： 院 （部）： 专 业： 班 级： 姓 名： 学 号： 指导教师： 翻译日期： 2017.02.14 Operational Amplifiers In 1943 Harry Black commuted from his home in New York City at Bell Labs in New Jersey by way of a ferry. The ferry ride relaxed Harry enabling him to do some conceptual thinking. Harry had a tough problem to solve; when phone lines were extended long distance, they needed amplifiers, and undependable amplifiers limited phone service. First, initial tolerances on the gain were poor, but that problem was quickly solved wuth an adjustment. Second, even when an amplifier was adjusted correctly at the factory, the gain drifted so much during field operation that the volume was too low or the incoming speech was distorted. Many attempts had been made to make a stable amplifier, but temperature changes and power supply voltage extremes experienced on phone lines caused uncontrollable gain drift. Passive components had much better drift characteristics than active components had, thus if an amplifier’s gain could be made dependent on passive components, the problem would be solve. During one of his ferry trips, Harry’s fertile brain conceived a novel solution for the amplifier problem, and he documented the solution while riding on the ferry. The solution was to first build an amplifier that had more gain than the application required. Then some of the amplifier output signal was fed back to the input in a manner that makes the circuit gain (circuit is the amplifier and feedback components) dependent on the feedback circuit rather than the amplifier gain. Now the circuit gain is dependent on the passive feedback components rather than the active amplifier. This is called negative feedback, and it is the underlying operating principle for all modern day opamps. Harry had documented the first intentional feedback circuit had been built prior to that time ,but t