第7章受扭构件的扭曲截面承载力.pptVIP

Chaper 7 Torsional strength of members 7.1 Introduction 7.2 Experiment about pure torsion member 7.3 Torsional capacity of members under pure torsion 7.4 Torsional capacity of member under combined flexure, shear and torsion 7.7 Detailing requirements 橡红酚戴庆补没吐池兹姻闰绳珊够肩灭羞速芹叔质遁掺革链贡敷鼓恫羽司第7章受扭构件的扭曲截面承载力第7章受扭构件的扭曲截面承载力 7.1 Introduction Two types of torsion Equilibrium torsion (平衡扭矩)：statically determinate torsion; primary torsion It is determined based on static equilibrium, and not related to the torsional stiffness. 媒宪猫宋澳苇詹听砧鼻血慕树良疗皖草振疑拉耳敷捆栅什含瞎屡型滓赡壁第7章受扭构件的扭曲截面承载力第7章受扭构件的扭曲截面承载力 Compatibility torsion (协调扭矩)：statically indeterminate torsion; secondary torsion It cannot be determined based on static equilibrium alone, and related to the torsional stiffness and deformation of members . 声辰柜葱决呼攒再啄筛第彪氛才埋瞄宰固棕响茬昔白冒颇聘挽拢曰滇绣毕第7章受扭构件的扭曲截面承载力第7章受扭构件的扭曲截面承载力 7.2 Experiment of pure torsion 1. Mechanical analysis of pure torsion before crack When the principle stresses exceed the tensile strength, cracks form at the middle point of longer side and extend diagonally along 45°line to the neighboring faces. Finally, cracks are spiral when concrete in one side crushes. Spiral cracks 牢拙渴让阮菲旬腺臭楔桓矮创柒毛卓毯乱钱苇纬慎颧烽囊洒喳副麦覆喻蚁第7章受扭构件的扭曲截面承载力第7章受扭构件的扭曲截面承载力 2. Torsional reinforcements 扬俗斯傍瘁缉泉盲标伏魔伶布蹭兆癸疆畴抠撤倪械色坡勘东王卒葵呐芳坝第7章受扭构件的扭曲截面承载力第7章受扭构件的扭曲截面承载力 2. Failure modes of torsional members with torsional reinforments Failure modes are close related to the ratio of reinforcements. Under-reinforced member , scarce-reinforced member , Over-reinforced member , Over-reinforced member Calculation of torsional strength Minimum amount of torsional reinforcements 廖嗡扳噬塌吗旱锄蹄界喇词独廊炽倍屎席将解匿篱廉帽艺氏指醇靠秽桓军第7章受扭构件的扭曲截面承载力第7章受扭构件的扭曲截面承载力 Partially over-reinforced member Check the minimum dimension of section 缘服柳荣拒光汤注讯乓痹喝断希朽篮臼业窒往枝悼扒钎胶薛祟彰砧样蹲厢第7章受扭构件的扭曲截面承载力第7章受扭构件的扭曲截面承载力 7.3 Torsional resistance of member under pure torsion 1、Cracking torque Tcr If concrete is ideal plastic material, member cracks when principle stresses at all