13.Screenprinting-Bi讲解.pptVIP

§13 Screen Printing Features of screen printing Flexional plate Thick ink layer,20 – 100um Roughness surface printable Curved surface printable Products have some sense of 3D,but low defination Application Paper printing：paper,cardboard,corrugated board Plastic container and toy Metal plate and metal container Glass Textile Architectural material Primary content and objectives Technics of screen printing To know the method of screen printing Application of screen printing Screen printing machine To know the construction and process of screen printing machines 13.1 Technics of screen printing 丝网印刷工艺 丝印制版Platemaking 印刷准备Preparation 安装刮墨板 安装丝网印版 安装回墨板 调配油墨 13.1.1 Platemaking Screen Frames There are diverse types of frames for screen printing.Wood, steel, and, more often, aluminum is used. Screen Fabric The type of fabric to be used depends only on the requirements arising from the process. The fabric’s material must allow good connection to the stencil material and must not be affected by the ink solvent or cleaning agents. It must be sufficiently abrasion-resistant to withstand the stress created when the squeegee is brought into contact with the substrate. Types:polyester,silk,nylon,stainless steel Stencil The carrier of the printed information, the stencil, is produced in a different way. Photographic Stencil Methods Indirect process Direct process Direct/Indirect process Indirect Process---P303 Figure 13.14 The indirect uses a dry emulsion on a plastic support sheet. The stencil film is exposed through a transparent, right-reading positive and is then treated with a developer solution. The areas that light reaches harden during exposure.The remaining areas are washed away with a warm-water spray to form the image or printing areas.The stencil is adhered to a clean screen while it is wet from the spray,and the support sheet is removed after the stencil dries. Direct Process---P304 Figure 13.15 The direct process uses a wet emulsi