Model CT(C) RS PROTOCOL【DOC精选】.doc

Model 6308 CT(Chinese) RS485 PROTOCOL (for firmware version 1.00+) Version BAUD : 9600 START : 1 DATA : 8 STOP : 1 PARITY : NONE Main Protocol ( ADDRESS ACKNOWLEDGE COMMAND DATA[0] . . . DATA[n] ADDRESS = 1 byte, 0-127 must add 128 to indicate as address ACKNOWLEDGE = 1 byte, must be equal to 6 COMMAND = 1 byte, valid commands = (0,3,4,5,6,11,12,13,14,15,16,17,20) DATA[0]-DATA[n]= depends on PARAMETER n = number of bytes II. DATA[0] – DATA[n] FORMAT IF COMMAND = 0 then DATA[0]..DATA[37] (page 0) FUNCTION : to get display data during normal operation. DATA[0] – DATA[5] = CONDUCTIVITY, ASCII FORMAT Possible readings: ‘+000.0’–’+999.9’,’+00.00’-’99.99’, ‘+0.000’-‘+9.999’,’OVER ‘,’+ LERR‘,’- LERR’,’+ TERR‘, ’- TERR’ “+ TERR” = Temperature OVER “- TERR” = Temperature UNDER “+ LERR” = Temp is higher than ccond. Temp limit “- LERR” = Temp is lower than ccond. Temp limit DATA[6] – DATA[11] = Temperature Value, ASCII Format Possible readings: ‘-010.0’ - ’+120.0’,’UNDER ‘,’OVER ‘ DATA[12] – DATA[17] = Analog Out (mA), ASCII Format Possible readings: ‘+03.00’ - ‘+22.00’, ‘OFF ‘ , ‘FROZEN’ ‘ERROR ’ ‘OFF ‘ = Analog system is OFF. ‘FROZEN’ = Analog output is frozen. ‘ERROR ’ = The difference between 4mA 20mA setting is less than or equal to 0.10 pH. DATA[18] – DATA[23] = TDS READING ASCII Format Possible readings: ‘+000.0’–’+999.9’,’+00.00’-’99.99’, ‘+0.000’-‘+9.999’,’OVER ‘,’+ LERR‘,’- LERR’,’+ TERR‘, ‘- TERR’ “+ TERR” = Temperature OVER “- TERR” = Temperature UNDER “+ LERR” = Temp is higher than ccond. Temp limit “- LERR” = Temp is lower than ccond. Temp limit DATA[24] – DATA[29] = Cell Constant, ASCII Format Possible readings: ‘0.0000’-‘9.9999’,’10.000’-’99.999’ DATA[30] – DATA[35] = Temperature Coefficient, ASCII Possible readings:’+00.00’-‘+04.99’ DATA[36] = 1 byte, FLAGS, binary coded Bit 0 = if 1 then RELAY