90000m3h电除尘器的设计与应用（含全套CAD图纸）【毕业论文+CAD图纸全套】.doc

90000m3/h电除尘器的设计与应用 摘 要：本设计针对某企业。量为90000m3/h，粉尘浓度为36g/m3。通过综合考虑企业工程概况及本设计的规模、进气特性、处理要求和运行费用等情况，最终确定主体采用电除尘工艺。相比其他除尘器有较好除尘效果，经过电除尘器排放的气体，最终出气可达到《》 本设计的内容主要包括90000m3/h企业废气处理的方案选择、工艺流程设计、各处理构筑物的参数计算及选型、企业高程布置计算和经济核算等。设计图纸的绘制包括工厂平面图、工艺流程图及主要构筑物的三视图。本设计建成的电除尘器将为城市带来环境和经济效益。 关键词：电除尘器 设计计算 安装及维护 工程造价  Design and application of 90000m3/h electrostatic precipitator AbstractThe design of a companys existing flue gas for the dust removal process design. The design and treatment of flue gas is 90000m3/h, the initial concentration of dust is 36000mg/m3. Based on the comprehensive consideration of the general situation of the enterprise project and the scale of the design, the intake characteristics, processing requirements and operating expenses, etc., the final determination of the main use of electrostatic dust removal process. Compared to other dust collector has the advantages of good dust removing effect, after the electric precipitator emissions of the gas, the final outlet can reach the boiler air pollutant emission standards (GB 13271 - 2014). The content of this design mainly includes the choice of the 90000m3/h enterprise waste gas treatment, process design, the parameters calculation and selection of each processing structure, enterprise elevation layout calculation and economic calculation and so on. Drawing of the design including the factory plan, process flow chart and the main structures of the three views. The electric dust collector which is built in this design will bring environmental and economic benefits to the city. Key words：Electric dust collector, Design calculation, Installation and maintenance, Engineering cost 目 录 第一章 文献综述 1 1.1 研究目的和意义 1 1.1.1 目的 1 1.1.2 意义 1 1.2 国内外研究现状、发展动态 2 1.2.1 粉尘污染控制及除尘器的发展 2 1.2.2 电除尘设备的市场不断扩大 5 1.2.3 结合气体净化设备发展除尘设备 5 第二章 整体设计计算 7 2.1 工程概况 7 2.1.1 企业烟气处理工程建设规模 7 2.1.2 烟气的性质 7 2.1.4 工程场地振动参数 8 2.1.5 煤成分分析 9 2.1.6 废气当中的粉尘颗粒的粒径分布表如下所示 9 2.1.7烟尘初始浓度的计算 9 2.2 除尘器的选择 10 2