内挡板冲孔模具设计【毕业论文+CAD图纸全套】.doc

摘要 此次我的毕业设计题目是内挡板冷冲压模具设计，经过对这个题目的分析与研究，最终确定了以落料→冲八孔→弯曲→冲狭长孔孔→压凸包的工序组合来完成这副模具的设计。此课题主要详细介绍了在内挡板冷冲压模具设计过程中，对各个工序的设计构想及具体实施方案，并且主要讲述模具设计工艺方案及工艺过程。 由于工作量大，所以此套模具由多人完成，而我设计的课题是内挡板冲孔模具的设计，在对冲压件工艺分析后我进行了方案比较与确定，然后以我自己的课题估算了模具各主要零件（凹模、凸模固定板、垫板，凸模）的外形尺寸，并确定标准模架以及卸料橡胶或弹簧的自由高度等。我设计的这副落料模的特点及原则是：该模具采用弹性卸料，并保证产品质量节约材料，降低劳动强度，降低成本，提高劳动生产率，最后达到产品的要求。 关键词：内挡板，冲压模具设计，冲孔，生产率Abstract This is my graduation design topic baffle in the cold stamping die design, through the analysis and Research on this topic, design and ultimately determine the process combination to blanking, punching hole, bending, blanking eight long Kong Kong, pressure hull to complete the mold. This paper mainly introduces the inner baffle plate cold stamping die design process, the design of each process and the concrete implementation scheme, and mainly about the design process of mold and process. Because of the heavy work load, so this set of die is made up of many people, and I design topic is the design of inner baffle plate punching die, the stamping process analysis I of scheme comparison and determined, and then to my own topic estimated the main die parts (die, punch plate, plate, punch) size, and to determine the standard mold and unloading rubber or spring free height. I designed this pair of blanking die and the characteristics of the principle is: the mold using the elastic unloading, and ensure the quality of products to save materials, reduce the labor intensity, reduce the cost, improve labor productivity, and finally achieve product requirements. Keywords: inner baffle plate, stamping mould design, punching, productivity 目录 第一章 概述…………………………………………………………………1 第二章 冲压工艺过程设计……………………………………………2 2.1 冲压工艺分析………………………………………………………………3 2.2 确定工艺方案………………………………………………………………6 第三章 冲压模具设计…………………………………………………17 3.1 确定模具结构形式………………………………………………………17 3.2 工件定位方式……………………………………………………………17 3.3卸料方式…………………………………………………………………17 3.4 模具设计计算 …………………………………………………………17 3.5 校核压力机………………………………………………………………19 第四章 结论……………………………………………………………20